Nexo N200 User manual

N200 6 Post Power Rack

PARTS
1x Standard Pull-up Bar
8x L Brackets 20x Upright Brackets
4x T Upright Brackets
2x Spotter Pins
Bolt Sets:
- 8x Long Bolt Sets
- 76x Regular Bolt Sets
2x Upper Ext. Crossbeams
2x Lower Ext. Crossbeams
1x Fat Pull-up Bar
2x Upper Crossbeams
2x Lower Crossbeams
1x Rear Crossbeam
8x Weight Pegs
6x Uprights
6x Rubber Feet
2x J-Cups

STEP 1
NOTE: Do not tighten any bolts until assembly is completed.
Lower Crossbeams
L Brackets
Rear Crossbeam
Assemble the base of the rack using 2x Lower Crossbeams, 1x Rear Crossbeam, 2x
Lower Ext. Crossbeams, 8x L Brackets, 12x Upright Brackets, and 26x Regular Bolt Sets.
Bracket Begins on the
3rd small hole
Bracket Begins on the
3rd small hole

STEP 2
Assemble the top of the rack using 2x Upper Crossbeams, 1x Regular Pullup Bar, 1x Fat
Pullup Bar, 4x T Upright Brackets, 4x Upright Brackets, and 8x Long Bolt Sets.
NOTE: In the setup below Regular pullup bar will be on the front of the rack
and Fat pullup bar in the middle. If you would like them flipped then do it on this step.
Fat Pullup Bar
Regular Pullup Bar
Upper Crossbeams
T Upright Brackets will
have 2 holes hanging o

STEP 3
Assemble 4x Uprights to the base of the rack using 8x Regular Bolt Sets. Keep in mind
that everything is not tightened so they will sway a bit. There is no top or bottom, just
make sure the 1inch holes are oriented like the picture.
NOTE: Remove the end caps from all of the uprights. You will
use four of these in a later step. A flat head screwdriver will work.

STEP 4
With a friend, install top of the rack from Step 2 onto the Uprights using 8x Regular Bolt
Sets. One person should hold the top in place while the other goes around to insert bolts.
The T Upright Brackets should be toward the back side.
T Upright Brackets
You can go ahead and
add 2 end caps here

STEP 5
Now we will setup the extension pieces using 2x Uprights, 2x Upper Ext. Crossbeams, 4x
Upright Brackets, and 10x Regular Bolt Sets.
NOTE: The Crossbeams will be placed flush with the uprights,
not above them. As you can see in the picture they are sitting on top
of the uprights, not on the ground.

STEP 6
The final steps are to connect the extensions pieces to the back of the rack using 8x
Regular Bolts and then install each weight peg to the extension using 16x Regular Bolts.
You can use another 2 end caps on the back of the rack on the Upper Ext. Crossbeams.
Now you may tighten all the bolts up, it will be easiest with a power drill
as we include locking nuts with every bolt set. If you have any questions at all
please don’t hesitate to call us at 904.747.0789 or email [email protected]