Nexo N300 User manual

Commercial Half Rack

All nuts and bolts use a 19mm socket or wrench.
PARTS CHECK
4x Uprights
A
A
2x Lower Crossbeams
B
B
2x Square Beams
C
1x Pull-up Bar
D
6x Upright Brackets
E
E
2x Bolt Down Brackets
F
2x J-Cups
G
56x Bolt Sets
H
8x Weight Pegs
I
1x Nameplate
J
H
G
F
I
FJ
D
C

STEP 1
Assemble each side of the rackon the ground—the only difference between each side is
the position of the Bolt Down Brackets.
Using 2x Uprights, 1x Lower Crossbeam, 1x Square beam, 3x Upright Brackets,
1x Bolt Down Bracket, and 16x Bolt Sets for each side.
Start the rear bracket on the 3rd hole from the back of the crossbeam
and the front bracket 7 holes after the rear bracket.

STEP 2
With a partner, stand each side up and connect the Pull-up bar at your
desired height using 4x bolt sets.

STEP 3
Now assemble the nameplate beam to the rear upright using 4x Bolt Sets.

STEP 4
Assemble the 8x Weight Pegs at your desired locations and then tighten up all bolts.
Congrats! Your rack is ready to use, be sure to check your bolts before every workout
If you have any questions at all please don’t hesitate to
call us at 904.747.0789 or email [email protected]