Nexo ePS6 User manual

PAGE 1 OF 2
- Read this document before using.
- Keep this document.
- Observe all warnings and cautions.
VNI-VCPL365
DP6130 –01 - DI
Coupler ePS6 eLS400
Contents:
X1 Top Frame
X1 Left Plate
X6
M10x20
X6
M10x30
X1 Right Plate
X2
M6x25
Weight: 8 kg / 17.6 lb

PAGE 2 OF 2
- Read this document before using.
- Keep this document.
- Observe all warnings and cautions.
Dimensions
Warnings
Ensure that the mounting location and
fasteners can support at least 4 times the
weight of all the installed cabinets, auxiliary
equipment and cables.
Use only the provided screws (thread lock
coated) and accessories.
Assembly
Remove the screws on both sides.
Assemble the Plates on each side of eLS400 using the M10x20 screws.
Place the assembly below the frame plate.
Pay attention to the mounting direction, see the
mark on the top frame.
Fasten the M10x30 screws.
Remove the screws on both sides of ePS6.
Place ePS6, fasten with M10x20 and M6x25
screws.
•NEXO cannot accept responsibility for accidents caused by any factor other than defects in this product itself.
•Please check the web site nexo-sa.com for the latest update.





 










