Next 845297 ella User manual

Tools Needed
Helpline
If you have any problems with this product or require
any replacement fittings plase contact Customer
Services Tel: [phone]
ASSEMBLY INSTRUCTIONS.
IMPORTANT - RETAIN FOR FUTURE REFERENCE - READ CAREFULLY.
Regrettably self assembly items cannot be returned once assembly is part or fully completed unless the item is found
to be faulty. Should you need to return the unassembled product, please repack in the original packaging.
IMPORTANT
• We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step instructions.
• Carefully check that you have all parts before beginning assembly.
• Keep fittings out of children's reach and keep children well away from the construction area.
• We recommend that the packaging is used to protect the surfaces during assembly.
• A minimum of 2 adults is required to assemble this product.
•WARNING: Do not use the bed if any part is broken, torn or missing and use only spare parts approved by the
manufacturer.
•WARNING: Do not place this bed near heat sources, windows and other furniture.
• Children are likely to play, bounce, jump and climb on beds, therefore the bed should not be placed too close to other
furniture or windows, and should be placed either tight to any wall or have a gap of 300mm between the wall and the
side of the wall and the side of the bed side.
PRODUCT INFORMATION
• Made in China.
•A mattress measuring 90cm x 190cm is intended for use with this bed.
CARE INSTRUCTIONS
• For general cleaning, periodically dust with a soft cloth.
• Do not rub or scrub the surface when cleaning.
• Do not use abrasive cleaning products or those containing silicone.
• Any spills should be removed immediately with a soft clean damp cloth and dried immediately.
• Avoid keeping furniture in direct sunlight or close to any heat sources as this can cause cracking, discolouration or
warping.
• Never drag pieces of furniture across the floor as this will cause damage to the joints.
• All assembly fixings should always be tightened properly and periodically check all fixings and tighten if necessary.
845297 ELLA
Page 1 of 3

1. Attach 4 x finials (L) to the ends of headboard (1)
and footboard (2) with 4 x bolts (D), tighten by hand
turning clockwise.
2. Attach 4 x foam pads (J) to the bottom of each leg.
1. Attach headboard (1) and footboard (2) to 2 x side
rails (4) with 8 x bolts (A), 8 x washers (E) and 8 x
rubber washers (F), using allen key (H) to tighten.
2. Attach barrier (3) to assembled unit with 4 x bolts
(C), using allen key (H) to tighten.
FITTINGS
PARTS
STEP ONE
STEP TWO
Page 2 of 3

1. Attach 2 x support rails (6) to 2 x side rails (4) with
4 x bolts (B), 8 x washers (E) and 4 x nuts (G), using
allen key (H) and spanner (I) to tighten.
1. Insert 30 x plastic caps (K) onto both ends of each
slat of the wooden slat assembly (5) . Ensure the
curve of the slats are facing upwards with the pins in
the caps facing downwards.
2. Insert plastic end caps (K) of the wooden slat
assembly (5) into the holes in side rails (4). Ensure the
curves of the slats are facing upwards.
3. Ensure the ends of the strap are wrapped around
support rails (6).
STEP THREE
STEP FOUR
STEP FIVE
Next Retail Ltd, Desford Road, Leicester, LE19 4AT
Page 3 of 3