Next CANTERBURY 818572 User manual

Tools Needed
Helpline
If you have any problems with this product or require
any replacement fittingsplase contact Customer
Services Tel: [phone]
•Do not rub or scrub the surface when cleaning.
•Do notuse abrasive cleaning products or those containing silicone.
•Any spills should be removed immediately with a soft clean damp cloth and dried immediately.
•Avoid keeping furniture in direct sunlightor close to any heat sources as this can cause cracking, discolouration or
warping.
•A minimum of 2 adults is required to assemble this product.
•Forgeneral cleaning, periodicallydust with a soft cloth.
PRODUCTINFORMATION
•Made in China.
•
A mattress measuring 90cm x 190cmisintended for use with this bed.
CARE INSTRUCTIONS
•Never drag pieces of furniture across the oor as this will cause damage to the joints.
•All assembly xings should always be tightened properly and periodically check all xings and tighten ifnecessary.
•We suggest you spend a short time reading through this leaet and then follow the simple step-by-step instructions.
•Carefully check that you have all parts before beginning assembly.
•Keep ttingsoutof children's reach and keep children well away from the construction area.
•We recommend that the packaging isused to protect the surfaces during assembly.
IMPORTANT - RETAIN FOR FUTURE REFERENCE - READ CAREFULLY.
ASSEMBLY INSTRUCTIONS.
Regrettably self assemblyitems cannotbe returned once assemblyispart or fully completed unless the item is
found to be faulty. Should you need to return the unassembled product, please repack in the original packaging.
IMPORTANT
818572 CANTERBURY BED - SINGLE
Page 1 of 4

1. Insert 28 x plastic caps 6 onto both ends of the
wooden slat assembly 5. Ensure the curve of the
slats are facing upwards.
1. Insert one side of plastic caps on the wooden slat
assembly into side rail 3. Ensure the curve of the
slats are facing upwards.
1. Insert the other side of plastic caps on the wooden
slat assembly into the remaining side rail 3. Ensure
the curve of the slats are facing upwards.
STEP ONE
FITTINGS
PARTS
STEP TWO
STEP THREE
Page 2 of 4

1. Attach 3 x support rails 4 to 2 x side rails with 6 x
bolts (B), 12 x washers (C) and 6 x nuts (E), using
Allen key (G) and spanner (H) to tighten.
2. Ensure the ends of the strap are wrapped around
support rails 4. The centre support rail should be
under the strap.
1. Attach headboard 1 and footboard 2 to the
assembled bed base with 8 x bolts (A), 8 x washers
(C) and 8 x rubber washers (D) using Allen key (G) to
tighten.
2. Insert 2 x lid 7 and 2 x finial 8 to headboard 1 base
with 2 x bolts(F), tighten by hand turning clockwise.
STEP FIVE
STEP SIX
STEP FOUR
Page 3 of 4

Next Retail Ltd, Desford Road, Leicester, LE19 4AT
Page 4 of 4