Next FORESTER NEST 803376 User manual

Tools Needed
Helpline
If you have any problems with this product or require
any replacement fittings please contact Customer
Services Tel: [phone]
damage.
• Do not put hot dishes directly on the surfaces of the item.
• Avoid keeping furniture in direct sunlight or close to any heat sources as this can cause cracking, discolouration or warping.
• Never drag pieces of furniture across the floor as this will cause damage to the joints.
• All assembly fixings should always be tightened properly and periodically check all fixings and tighten if necessary.
• Carefully check that you have all parts before beginning assembly.
• Keep fittings out of children's reach and keep children well away from the construction area.
• Ensure the product is protected with mats and coasters when items are placed on the surfaces, to prevent scratching or
• Ensure the mats and coasters used do not have an abrasive surface underneath.
PRODUCT INFORMATION
• Made from particleboard,MDF with a wood effect finish.
• Made in Indonesia.
CARE INSTRUCTIONS
IMPORTANT
• We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step instructions.
ASSEMBLY INSTRUCTIONS.
IMPORTANT - RETAIN FOR FUTURE REFERENCE - READ CAREFULLY.
Regrettably self assembly items cannot be returned once assembly is part or fully completed unless the item is found to be faulty.
Should you need to return the unassembled product, please repack in the original packaging.
• We recommend that the packaging is used to protect the surfaces during assembly.
• A minimum of 2 persons is required to assemble this product.
• For general cleaning, periodically dust with a soft cloth.
• Do not rub or scrub the surface when cleaning.
• Any spills should be removed immediately with a soft clean damp cloth and dried immediately.
803376 FORESTER NEST
1 of 3

P6x20 mm. 6 mm. 6x13 mm.
PARTS
FITTINGS
Ax8 Bx8 Cx8
1x1 2x4 3x1 4x4
2 of 3

- Attach panel 2 to panel 1 and tightening 4x washers (C),
4x ring washers (B) and 4x bolts (A) clockwise with a
cross-blade screwdriver until tight.
- Attach panel 4 to panel 3 and tightening 4x washers (C),
4x ring washers (B) and 4x bolts (A) clockwise with a
cross-blade screwdriver until tight.
Recommend to use cross-blade screwdriver.
- Carefully turn the unit upright.
- Now, Nest table is ready for use.
STEP TWO
Next Retail Ltd, Desford Road, Leicester, LE19 4AT
STEP ONE
2
22
1
2
4
4
3
44
3 of 3