Next HARTFORD 138311 User manual

Tools Needed
Helpline
If you have any problems with this product or require
any replacement fittings please contact Customer
Services Tel: [phone]
CARE INSTRUCTIONS
• Natural features ensure that each piece is individual. Every effort is made to ensure colour continuity between
pieces, however this is a natural product, slight colour variations and natural grain markings may occur.
• We recommend that the packaging is used to protect the surfaces during assembly.
PRODUCT INFORMATION
• Made from Pine with NC lacquer finish.
• Avoid keeping furniture in direct sunlight or close to any heat sources as this can cause cracking, discolouration or
warping.
• Never drag pieces of furniture across the floor as this will cause damage to the joints.
• Ensure the product is protected with mats and coasters when items are placed on the surfaces, to prevent
scratching or damage.
• Do not put hot dishes directly on the surfaces of the item.
• We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
ASSEMBLY INSTRUCTIONS.
Regrettably self assembly items cannot be returned once assembly is part or fully completed unless the item is found
to be faulty. Should you need to return the unassembled product, please repack in the original packaging.
IMPORTANT
IMPORTANT - RETAIN FOR FUTURE REFERENCE - READ CAREFULLY.
• Keep fittings out of children's reach and keep children well away from the construction area.
• Carefully check that you have all parts before beginning assembly.
• Always use a non-silicone based furniture polish. Silicone in furniture polishes can break down the lacquer finish.
• Made in China.
• A minimum of 2 persons is required to assemble this product.
• Do not rub or scrub the surface when cleaning.
• For general cleaning, periodically dust with a soft cloth.
• Any spills should be removed immediately with a soft clean damp cloth and dried immediately.
• All assembly fixings should always be tightened properly and periodically check all fixings and tighten if necessary.
138311 HARTFORD ROUND DINING TABLE
Page 1 of 4

1. Insert 8 x dowel (D) into 4 x panel (2)
& 4 x panel (3).
STEP ONE
PARTS
FITTINGS
Page 2 of 4

1. Attach 4 x panel (2) to cube (4)
2. Insert 8 x washer (A) into screws on panel (2)
3. Thread in 8 x screw nut (B) to screws and tighten
with a open wrench (C ).
1. Attach assembled unit to bottom of top panel (1).
2. Insert 8 x bolt screw (E) into panels (2) and tighten
with a allen key.
1. Attach 4 x legs (3) to cube (4)
2. Insert 8 x washer (A) into screws on legs (3)
3. Thread in 8 x screw nut (B) to screws and tighten
with a open wrench (C ).
STEP TWO
STEP THREE
STEP FOUR
Page 3 of 4

1. Turn assembled unit stand up.
1. Placed the cap (5) onto cube (4)
STEP SIX
STEP FIVE
Next Retail Ltd, Desford Road, Enderby, Leicester, LE19 4AT
Page 4 of 4