Next SOPHIE CABIN STATION 889951 User manual

Tools Needed
Helpline
If you have any problems with this product or require
any replacement fittings please contact Customer
Services Tel: [phone]
PRODUCT INFORMATION
FITTINGS
• Do not put hot dishes directly on the surfaces of the item.
• Any spills should be removed immediately with a soft clean damp cloth and dried immediately.
• Do not rub or scrub the surface when cleaning.
• For general cleaning, periodically dust with a soft cloth.
• Made from MDF with a painted finish.
• We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step instructions.
• Avoid keeping furniture in direct sunlight or close to any heat sources as this can cause cracking, discolouration or
warping.
• Carefully check that you have all parts before beginning assembly.
• Keep fittings out of children's reach and keep children well away from the construction area.
• We recommend that the packaging is used to protect the surfaces during assembly.
• A minimum of 2 persons is required to assemble this product.
• Not suitable for use in bathrooms.
CARE INSTRUCTIONS
• Ensure the product is protected with mats and coasters when items are placed on the surfaces, to prevent
scratching or damage.
• Made in China.
• Always use a non-silicone based furniture polish. Silicone in furniture polishes can break down the lacquer finish.
ASSEMBLY INSTRUCTIONS.
Regrettably self assembly items cannot be returned once assembly is part or fully completed unless the item is found
to be faulty. Should you need to return the unassembled product, please repack in the original packaging.
IMPORTANT
IMPORTANT - RETAIN FOR FUTURE REFERENCE - READ CAREFULLY.
• Never drag pieces of furniture across the floor as this will cause damage to the joints.
• All assembly fixings should always be tightened properly and periodically check all fixings and tighten if necessary.
889951 SOPHIE CABIN STATION - DESK
B x 4 C x 8 D x 11
Page 1 of 5

1. Insert 4 x wooden dowels (C) into bottom frame 6.
2. Attached side panel 2-L and side panel 2-R to
bottom frame 6 with 4 x screws (B) and tighten with a
screwdriver.
1. Insert 4 x wooden dowels (C) to top panel 1 .
2. Attached top panel 1 to the assembled unit with 4 x
bolts (A) and tighten with a screwdriver .
PARTS
STEP TWO
STEP ONE
C
C
6
2-L
C
Page 2 of 5

1. Insert back panel 4 to the groove of top panel 1.
2. Attach back panel 4 to the body of desk with 11 x
screws (D) and tighten with a screwdriver.
1. Insert 8 x shelf supports (E) into side panel 2 (both
L&R), ensure each four supports of each shelf are all
at the same height.
2. Insert 2 x adjustable shelves 5 onto the shelf
supports (E).
1. Insert desk into the runners of Bed.
STEP THREE
STEP FOUR
STEP FIVE
EE
Page 3 of 5

1. Attach stop bar 3 to the end of top panel 1 with 2 x
bolts (A).
2. Attach 2 x rubber stoppers (F) to the stop bar 3.
Position as shown
STEP SIX
STEP SEVEN
Page 4 of 5

PACKAGING LAYOUT
Next Retail Ltd, Desford Road, Leicester, LE19 4AT
Page 5 of 5