Nexus SW-NX30 Operating instructions

SI-76X0A
SW-NX30 Hub Dynamo Switch
SERVICE INSTRUCTIONS
Before use‚ read these instructions carefully‚ and follow them for correct use.
If the switch is operated while riding the bicycle, you may lose control
of the bicycle, and a serious accident may result. Be sure to dismount
from the bicycle before operating the switch.
Obtain, read and carefully service instructions when installing parts.
A loose, worn, or damaged parts may cause injury to the rider.
We strongly recommend that only genuine Shimano replacement
parts be used.
Be sure to read the Service Instructions for the HB-NX30 hub dynamo
together with these instructions.
NOTE
Be sure to periodically clean the luminance sensor receptor on the bottom of the
switch, because if mud or similar gets onto the sensor receptor, it may cause the
sensor to operate incorrectly.
Operation of the switch
Luminance sensor receptor
WARNING
ON: The light is always turned on.
AUTO: The light will switch on automatically when it becomes dark.
OFF: The light is always turned off.
t

Set so that it faces the right way.
Note:
Press in until you hear a click.
Bend
Insert
Bend the cable wires and run them
along the grooves.
Do not allow the cable wires to touch
each other.
5 – 10 mm
16 mm
Brown
Black
Connector cap
(gray)
HB-NX30
SW-NX30
Nut
Washer
Switch bracket
Mudguard
Bolt
Install the switch so that it
does not protrude outside the
line of the front fork, and so
that it does not touch the
mudguard.
Note:
Run the cable along the front
fork and secure it in place with
tape or a plastic tie.
Front fork
Mudguard
Switch
Installation of the switch and connection of the cables
Connector cover
(black)
Note:
Do not switch over the brown cable
and the black cable by mistake. If the
cables are connected incorrectly, the
light will not illuminate.
Frame connection terminal
Light connection terminal
HB-NX30

Cable fixing plate
Cable fixing screw
Cable fixing plate
Do not remove the bracket fixing screw.
Note:
Taillight cables
Connection of cables to the switch
These service instructions explain how to use and maintain the
Shimano bicycle parts which have been used on your new bicycle.
For any questions regarding your bicycle or other matters which
are not related to Shimano parts‚ please contact the place of
purchase or the bicycle manufacturer.
Nov. 1999 by Shimano Inc. PIT. SZK. Printed in Singapore
C
Please note: Specifications are subject to change for improvement without notice. (English)
Front light cables Taillight cables
One Holland Irvine CA 92618 U.S.A. Phone [phone]
Industrieweg 24 NL-8071 CT Nunspeet‚ Holland Phone [phone]
3-77 Oimatsucho‚ Sakai‚ Osaka‚ Japan Phone [phone]
t