Nexus IB10 Technical manual

1Nexus IB10 USB Update Instructions
Nexus IB10 USB Update Instructions
1. Copy the following downloaded files to the root of a USB flash drive
(Must be formatted to fat32)
sba_xml.b10.bin
sba_sys.b10.bin
sba_dsp.b10.bin
sba_app.b10.bin
sba_logo.b10.bin
2. Insert the USB flash drive into either of the USB ports located on the rear panel of the
IB10
3. From the IB10 Main screen, click Settings.

2Nexus IB10 USB Update Instructions
4. From the Settings screen, select System
5. From the System screen, select Update

3Nexus IB10 USB Update Instructions
6. Select USB
7. At this point the system will begin to update. A progress bar will be displayed during the
update process. When the initial update is complete the system will prompt you to
restart the system. It is important to leave the USB drive in place during the system
restart.
Once the system restarts, the system may display a pop-up stating an update is
necessary. If so, click OK. A few additional files will be copied and an additional reboot
will be required. At this point the system is updated. Navigate to the system screen to
confirm (see step 5 of this document)