Nice Planter Corten Trough T4 User manual

TM
Watch how to easily assemble the planter on
Keyword: Corten Trough T4
Philips head screwdriver
Threaded screw QTY 10
Thread cutting screw QTY 1*
only use if thread is stripped
Recommended Tools :
Assembly Directions
Step 1 :
Note: The screw holes are threaded and should easily screw in with a screw driver. The drill should
not be used as it can lead to stripping of the thread and screws.
Place the oor panel inside the side panel as
illustrated. Line up the screw holes. With the
help of a screwdriver, tighten the screws.
Step 2 :
Using the second side panel, repeat Step 1
Step 3 :
Line up the end panel downward-bent lip with
the top corner opening of the side panels.
Step 4 :
Insert the end panel downward-bent lip into
the top corner openings of the side panels.
Screws
Planter Panels Side
End End
Side
Floor

For Customer Support Please Call 206.486.0936
Or Email [e-mail]
on the Web at NicePlanter.com
Planters Designed in US and Fabricated in China
Nice Planter LLC - Patent Pending
Step 5 :
After the top edges of the end panels and side
panels are interlocked, align the bottom of the
end panels with the bolt holes in the oor panel.
Thread the four screws through the
corresponding holes and tighten the nuts.
Place the corrugated plastic wall liner sheets
inside the planter to insulated the planter from
direct sun and heat.
Step 6 :

1 | P a g e For Customer Support Please Call 206.486.0936
Or Email [email protected] on the Web at NicePlanter.com
Planters Designed in US and Fabricated in China - Nice Planter LLC –Patent Pending
Assembly Instructions –Caster Frame
Required tools: Two 17mm wrenches
Loosen the bolts and nuts that attach the casters to the smaller section of the
frame (leave the nuts on the bolts). Loosening the bolts will allow for easier
alignment of all bolt holes.
Place the longer section of the frame on top of the shorter section of the frames.
Align the holes of the two frame sections and place the bolts through. Put on the
nuts, but do not fully tighten with wrenches until all bolts are in place.

2 | P a g e For Customer Support Please Call 206.486.0936
Or Email [email protected] on the Web at NicePlanter.com
Planters Designed in US and Fabricated in China - Nice Planter LLC –Patent Pending
Once the frame is fully assembled and all bolts are in place, tighten all the nuts as
tight as possible.
Warning: The caster frame and planter is to be used on level and even surfaces.
Note: If you plan to frequently roll the planter around consider reducing the
amount of soil placed in the planter. This will make the planter less heavy and
easier to roll. For ideas of what can be used as light filler please visit our blog at
NicePlanter.com