Nickel-Electro Clifton Range CM-1 User manual

High quality products at aordable prices
CYCLONE VORTEX MIXER
CM-1

CYCLONE MIXER CM-1
CLIFTON RANGE® - 3 YEAR WARRANTY
2
Dear Customer
The Clifton Range® is part of Nickel-Electro Ltd a family rm based in Weston-Super-
Mare which was incorporated as a limited company in 1941 but its roots can be traced
back to 1935 when the business rst started. Now in its 3rd generation of family
members, the company prides itself on being a strongly established, independant
British manufacturer.
Thank you for purchasing this piece of Clifton Range® equipment. To get the best
performance from your equipment and for your own safety please read these
instructions carefully before use.
GENERAL NOTES
1. This product is designed for laboratory use only. Always follow good laboratory
practice.
2. If this product is not used in accordance with these instructions then basic safety
protection may be aected.
3. The mains supply cord tted to this product is heat resistant and should be
replaced with an equivalent type by a qualied electrician.
4. Ensure that the power supply has a safety earth (ground) terminal.
5. Connect to a mains power supply with RCD protection if possible.
6. Ensure that the mains switch and power supply connector are accessible during
use.
7. Before using any cleaning or decontamination method please refer to the
Maintenance and Cleaning section to ensure the proposed method will not
damage the unit.
8. Connect only to a power supply with the corresponding voltage to that specied
on the rating label positioned on the rear of the unit.
9. Over voltage category II (IEC 644) and Pollution Degree 2 (IEC 644).
10. WEAR SAFETY GOGGLES WHEN MIXING.

CYCLONE MIXER CM-1
CLIFTON RANGE® - 3 YEAR WARRANTY
3
!
!
LOCATION
The product must be placed on a smooth, level and sturdy work surface. Suitable for use
in ambient temperatures 5°C to 40°C with a maximum humidity 80% (temperature 31°C)
decreasing to 50% (temperature 40°C). Mains voltage uctuations are not to exceed +/-
10˚% of the nominal supply.
UNPACKING
Remove the product from its packaging and retain over the warranty period. Contents
consist of:
• Cyclone vortex mixer
• Power lead
• Instruction manual
Fit the power lead into the socket at the rear.
SAFETY
Do not touch any electrical contacts or open any closure panels.
RISK OF ELECTRIC SHOCK!!
POWER LEAD AND CONNECTION TO ELECTRICAL SUPPLY
Check the electrical supply is compatible with the rating label.
IF IN DOUBT CONSULT AN ELECTRICIAN. THE PRODUCT MUST BE
EARTHED!
Where the mains supply or plug connection diers refer to local
regulations or consult an electrician.

OPERATING INSTRUCTIONS
1. Switch the cyclone mixer ON using the green rocker switch. The switch will
illuminate.
2. The mixing speed can be varied by turning the dial anticlockwise to decrease or
clockwise to increase the mixing intensity.
3. When placing the tube for mixing onto the Cyclone’s rubber cup always select a
slow speed and gradually adjust the dial to produce the desired vortex.
4. The Cyclone mixer can be operated in two ways - manually or automatic.
MANUAL MODE: press start operation providing instant action the
moment the tube is pressed into the rubber cup.
AUTOMATIC MODE: the rubber mixing cup rotates continuously.
CARE AND MAINTENANCE
Please ensure that the washing agent and sanitizing agent are BSI accredited and
approved by the H&S department for use on laboratory equipment and stainless steel
within your laboratory.
DISCONNECT THE MIXER FROM THE POWER SUPPLY PRIOR TO
CLEANING
Only use a damp cloth and mild detergent to wipe clean the outside surfaces.
Disconnect the unit from the mains electrical supply before cleaning. Ensure the unit is
completely dry.
PORTABLE APPLIANCE TESTING
These tests should be conducted by a qualied person.
DO NOT PAT test the boiling bath unless it contains water.
DO NOT Flash Test!!
CYCLONE MIXER CM-1
CLIFTON RANGE® - 3 YEAR WARRANTY
4
!
!
!
oc