Nikon AF-10 User manual

- 1 -
User’s Manual
Auto Document Feeder
AF-10
Contents
Introduction
Installing the AF-10
Using the AF-10
Loading Documents Manually
Troubleshooting
Specifications
Paper Limitations

- 2 -
Cautions
• The reproduction of all or part of this manual without our
permission is prohibited.
• The information contained in this manual is subject to change
without notice.
• We have made every effort to produce a perfect manual,
but should you find any mistakes, we would be grateful if you
would kindly let us know.
• We cannot assume any responsibility for consequences
resulting from the operation of this product, despite the
terms mentioned above.
Federal Communications Commission (FCC)
Radio Frequency Interference Statement
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
CAUTION
Modifications
The FCC requires the user to be notified that any changes or
modifications made to this device that are not expressly
approved by Nikon Corporation may void the user’s authority
to operate the equipment.
Notice for customers in Canada
CAUTION
This class B digital apparatus meets all requirements of the
Canadian Interference Causing Equipment Regulations.
ATTENTION
Cet appareil numérique de la classe B respecte toutes les
exigences du Règlement sur le matériel brouilleur du Canada.

- 3 -
Introduction
Thank you for purchasing the Nikon Auto Document Feeder
AF-10 for the full-color flatbed scanner ScanTouch 110.
This manual describes the procedure for setting up the AF-10
and connecting it to the ScanTouch 110. Please read this
manual thoroughly to ensure proper installation and operation
of the unit.
For practical procedures on how to scan and reproduce images
using the ScanTouch 110 with the Automatic Document
Feeder AF-10, please refer to the software manual.
We hope that you find this manual helpful.
Accessories
The following items are included with your Auto Document
Feeder AF-10. On opening the package, if any items are
missing, please contact your dealer immediately.
• Auto Document Feeder AF-10 (1)
• Open Me First envelope (1)
• User’s Manual (1)
Installing the AF-10
1. Turn off your scanner and unplug its power cord from the
AC power outlet.
2. Remove the document cover from the scanner.
Document cover

- 4 -
3. Fit the two holes in the hinge plate of the AF-10 over the
small supporting posts on the scanner.
4. Gently slide the AF-10 so that the supporting posts move
into the narrow sections of the holes.
5. Attach the AF-10 with the two lockdown screws provided.
Insert screws into the center of each hinge bracket and use a
coin to tighten the screws securely.
6. Connect the AF-10 interface cable to the connector on the
rear panel of the scanner.
7. Plug in the scanner’s power cord and turn the power switch
on.
Note: When you remove the AF-10, store the two lockdown
screws in the holes on the back of the unit, until they are needed
again.

- 5 -
Using the AF-10
Begin by removing any document from the document setting
glass of the scanner, and then make sure that the AF-10 is
closed.
1. Turn the scanner on.
2. Place the documents in the upper tray, face up, as shown.
The AF-10 can be loaded with up to 50 sheets (a stack
thickness of 6 mm or less) of the following paper sizes:
Check size 3 x 5 inches (76mm x 127mm)
A5 5.8 x 8.3 inches (148.5mm x 210mm)
B5 7.2 x 10.1 inches (182mm x 257mm)
A4 8.3 x 11.7 inches (210mm x 297mm)
Letter 8.5 x 11 inches (216mm x 279mm)
Legal 8.5 x 14 inches (216mm x 356mm)
3. Slide the paper guides on the upper tray towards each other,
until they just contact the edges of the document stack.
4. After aligning the document stack, insert the documents until
you can feel them contact the document-stopper of the
AF-10.

- 6 -
Loading Documents Manually
You can still load documents manually, even with the AF-10
installed.
1. Open the front end of the AF-10.
2. Place the document on the document setting glass of the
scanner, then lower the AF-10 and initiate the scan.

- 7 -
Troubleshooting
Removing a Jammed Document
1. Raise the cover of the AF-10.
2. (Condition 1)
If the jammed paper is at the exit of the AF-10, lift the upper
tray, and slowly pull the jammed paper toward you until it is
fully released from the feeder mechanism.
(Condition 2)
If the jammed paper has not yet arrived at the exit of the
AF-10, slowly pull the jammed paper backward until it is fully
released.
3. After removal of the jammed document, gently close the
cover of the AF-10.

- 8 -
Replacing theTransparent Sheet
The quality of your scans may degrade overtime. Quite often
this is caused by a scratched or dirty Transparent Sheet. You
can contact your dealer to purchase a replacement. To replace
a worn Transparent Sheet, follow these steps:
1. Raise the cover of the AF-10.
2. Remove the Transparent Sheet from the AF-10 by pulling
the two hooks of the Transparent Sheet toward you, and
pushing it up.
3. Insert the transparency edge of the new Transparent Sheet
between the paper guide (A or B) of the AF-10, with the
white sheet to the lower side.
4. Insert the two hooks of the Transparent Sheet into the
AF-10.
5. Push down the two protrusions of the Transparent Sheet as
far as they will go.
6. Gently close the cover of the AF-10.

- 9 -
Specifications
Weight: 10.0 lbs (4.5kg)
Dimensions: 12.7 (W) x 20.6 (D) x 4.1 (H) inches
(322 x 524 x 104mm)
Paper capacity: 6mm document stack (50 pages for 0.1t
paper)
Operating Environment:
Temperature: 41°F to 95°F (5°C to 35°C)
Humidity: 20 to 85% R.H. (no condensation)
Storage Environment:
Temperature: –4°F to 140°F (–20°C to 60°C)
Humidity: under 95% R.H. (no condensation)
Paper Limitations
Size:
Width: 3.0 to 8.5 inches (76 to 216mm)
Length: 5.0 to 14 inches (127 to 356mm)
Thickness: 0.065 to 0.145 mm
Weight: 50 to 127 g/mm
Paper Quality:
Copy Paper
Document Condition:
Use with ink that will not be transferred to the
rollers. Torn, holed, wrinkled, or folded paper,
paper with adhesive tape, carbon, or paper
clips attached, or paper with wet ink, can cause
a paper jam or damage to the AF-10.

- 10 -
ERKLÄRUNG ÜBER EG-NORMENGERECHTHEIT
Wir
Name: Nikon UK Limited
Anschrift: Nikon House, 380 Richmond Road, Kingston,
Surrey KT2 5PR, UK
erklären hiermit, daß das folgende Produkt
Produktbezeichnung: Automatischer Vorlageneinzug AF-10
Name des Herstellers: Nikon Corporation
Anschrift des Herstellers: Fuji Bldg., 2-3, Marunouchi 3-chome, Chiyoda-
ku, Tokyo 100, Japan
den nachstehend aufgeführten Normen genügt:
EN55022 Klasse B
EN50082-1
IEC801-2: 1984 8kV
IEC801-3: 1984 3V/m
IEC801-4: 1988 1kVAC, 0.5kV, I/O
und zwar gemäß den Bestimmungen der EMC-Richtlinie (89/336/EEC)
DECLARACIÓN DE CONFORMIDAD DE LA CEE
Nosotros
Nombre: Nikon UK Limitada
Dirección: Nikon House, 380 Richmond Road, Kingston,
Surrey KT2 5PR, UK
declaramos que este producto
Nombre del producto: Alimentador automático de documentos AF-10
Nombre del fabricante: Nikon Corporation
Dirección del fabricante: Fuji Bldg.,2-3, Marunouchi 3-chome, Chiyoda-ku,
Tokyo 100, Japón
es conforme a las normas siguientes
EN55022 Clase B
EN50082-1
IEC801-2: 1984 8kV
IEC801-3: 1984 3V/m
IEC801-4: 1988 1kVCA,0,5kV E/S
según las disposiciones de la directiva de la CEE (89/336/EEC)
EC DECLARATION OF CONFORMITY
We
Name: Nikon UK Limited
Address: Nikon House, 380 Richmond Road, Kingston,
Surrey KT2 5PR, UK
declare that the product
Product Name: Auto Document Feeder AF-10
Manufacturer’s Name: Nikon Corporation
Manufacturer’s Address: Fuji Bldg., 2-3, Marunouchi 3-chome, Chiyoda-
ku, Tokyo 100, Japan
is in conformity with the following Standards
EN55022 Class B
EN50082-1
IEC801-2: 1984 8kV
IEC801-3: 1984 3V/m
IEC801-4: 1988 1kVAC, 0.5kV, I/O
following the provisions of the EMC Directive (89/336/EEC)
DECLARATION DE CONFORMITE DE LA CEE
Nous
Nom: Nikon UK Limited
Address: Nikon House, 380 Richmond Road, Kingston,
Surrey KT2 5PR, UK
déclarons que ce produit
Nom du produit: Chargeur Feuille à Feuille AF-10
Nom du fabricant: Nikon Corporation
Adresse du fabricant: Fuji Bldg., 2-3, Marunouchi 3-chome, Chiyoda-
ku, Tokyo 100, Japan
est conforme aux normes suivantes
EN55022 Classe B
EN50082-1
IEC801-2: 1984 8kV
IEC801-3: 1984 3V/m
IEC801-4: 1988 1kVAC, 0.5kV, I/O
selon les dispositions de la directive de la CEE (89/336/EEC)
Kingston, UK March 1, 1996
Place Date Signature/Managing Director
Lieu Date Signature/Directeur général
Ort Datum Unterschrift/Geschäftsführer
Lugar Fecha Firma/Director general