Ninebot KickScooter F20A User manual

CE.00.0042.28-B
The manufacturer reserves the right to make changes to the product, release firmware updates, and update this
manual at any time. Visit www.segway.com or check the Segway-Ninebot app to download the latest user materials.
You must install the app, activate your KickScooter, and obtain the latest updates and safety instructions.
Ninebot KickScooter
F20A / F30 / F30A / F40 / F40A
Product Manual
EN
The pictures shown are for illustration purposes only. The actual product may vary.

Diagram
1
EN
Dashboard & Power Button
Bell
Handlebar
Electronic Throttle
Snap Hook
Dashboard & Power Button
Safety Hook
Brake Lever
Headlight
Stem
Folding Mechanism
Quick-release Lever
Front Fork
Front Fender
Hub Motor
Charging Port
Footboard
Buckle
Rear Fender
Rear Light
Disc Brake
Reflector*
* For F20A, F30A, and F40A.
Reflector*
* For F20A, F30A, and F40A.
Kickstand
Battery Compartment
Power Button: Press the button to turn on; press and hold the button for 3 seconds to turn off. When the KickScooter is on, press the button
to turn on/off the headlight and the rear light, and press twice to switch between the speed modes.
Speedometer: It displays the current speed of the scooter, as well as error codes.
Speed Mode: There are three modes available. The top speed is as follows:
Error Notification: It indicates that the scooter has detected an error.
Temperature Warning: It indicates that the battery temperature has reached 122°F (50°C) or is below 32°F (0°C).
* At this point, the vehicle cannot accelerate normally and may not be charged. Do not use until the temperature has
reverted to the normal range.
Bluetooth: It indicates that the scooter has been successfully connected to the mobile device.
Battery Level: The total battery level equals 5 bars.
* The battery power is very low when the first battery bar is red. Please charge your KickScooter immediately.
Speedometer
Bluetooth
Headlight
Temperature Warning
Speed Mode
Error Notification
Battery Level
Power Button
Model
Mode F20A
15 km/h (9.3 mph)
25 km/h (15.5 mph)
25 km/h (15.5 mph)
F30
15 km/h (9.3 mph)
25 km/h (15.5 mph)
25 km/h (15.5 mph)
F30A
15 km/h (9.3 mph)
25 km/h (15.5 mph)
25 km/h (15.5 mph)
F40
15 km/h (9.3 mph)
30 km/h (18.6 mph)
30 km/h (18.6 mph)
F40A
15 km/h (9.3 mph)
25 km/h (15.5 mph)
25 km/h (15.5 mph)
ECO (Energy-saving mode)
D (Standard mode)
S (Sport mode)
01 02

Approx. 1143 × 480 × 1160 mm (45 × 18.9 × 45.7 in)
Approx. 1143 × 480 × 495 mm (45 × 18.9 × 19.5 in)
Approx. 14.5 kg (32 lbs)
Specifications
2
Product
Rider
Machine
Battery
Motors
Charger
Ninebot KickScooter
F20A
Item Parameter
Name
Model
Length × Width × Height
Folded: Length × Width × Height
Net Weight
Payload
Recommended Age
Required Height
Max. Speed
Typical Range[1]
Max. Slope
Traversable Terrain
Operating Temperature
Storage Temperature
IP Rating
Duration of Charging
Nominal Voltage
Max. Charging Voltage
Charging Temperature
Nominal Capacity
Nominal Energy
Battery Management System
Output Power
Input Voltage
Max. Output Voltage
Rated Output
Brake Light
Speed Mode
Tire Pressure
Tires
45–50 psi
10-inch pneumatic tires
LED Rear Light
Energy-saving mode, Standard mode and Sport mode
0.07 kW, 70 W
100–240 V~
42 V
41 V , 1.7 A
Nominal Power 0.25 kW, 250 W
36 V
42 V
0–40°C (32–104°F)
5100 mAh
183 Wh
Over-heating, short circuit, over-current, over-discharge and
over-charge protection
Approx. 25 km/h (15.5 mph)
Approx. 20 km (12.4 miles)
Approx. 10%
Asphalt/flat pavement; obstacles < 0.4 in (1 cm); gaps < 1.2 in (3 cm)
-10–40°C (14–104°F)
-10–50°C (14–122°F)
IPX5
Approx. 3.5 h
30–100 kg (66–220 lbs)
14–60 years
120–200 cm (3’11”–6’6”)
[1] Typical Range: tested while riding under full power, 75 kg (165 lbs) load, 25°C (77°F), 60% of max. speed on average on pavement.
* Some of the factors that affect range include speed, number of starts and stops, ambient temperature, etc.
Features
Tire
Approx. 1143 × 480 × 1160 mm (45 × 18.9 × 45.7 in)
Approx. 1143 × 480 × 495 mm (45 × 18.9 × 19.5 in)
Approx. 15.2 kg (33.5 lbs)
Product
Rider
Machine
Battery
Motors
Charger
Ninebot KickScooter
Item Parameter
Name
Model
Length × Width × Height
Folded: Length × Width × Height
Net Weight
Payload
Recommended Age
Required Height
Max. Speed
Typical Range[1]
Max. Slope
Traversable Terrain
Operating Temperature
Storage Temperature
IP Rating
Duration of Charging
Nominal Voltage
Max. Charging Voltage
Charging Temperature
Nominal Capacity
Nominal Energy
Battery Management System
Output Power
Input Voltage
Max. Output Voltage
Rated Output
Brake Light
Speed Mode
Tire Pressure
Tires
45–50 psi
10-inch pneumatic tires
LED Rear Light
Energy-saving mode, Standard mode and Sport mode
0.07 kW, 70 W
100–240 V~
42 V
41 V , 1.7 A
Nominal Power 0.3 kW, 300 W
36 V
42 V
0–40°C (32–104°F)
7650 mAh
275 Wh
Over-heating, short circuit, over-current, over-discharge and
over-charge protection
Approx. 25 km/h (15.5 mph)
Approx. 30 km (18.6 miles)
Approx. 15%
Asphalt/flat pavement; obstacles < 0.4 in (1 cm); gaps < 1.2 in (3 cm)
-10–40°C (14–104°F)
-10–50°C (14–122°F)
IPX5
Approx. 5 h
30–100 kg (66–220 lbs)
14–60 years
120–200 cm (3’11”–6’6”)
[1] Typical Range: tested while riding under full power, 75 kg (165 lbs) load, 25°C (77°F), 60% of max. speed on average on pavement.
* Some of the factors that affect range include speed, number of starts and stops, ambient temperature, etc.
Features
Tire
Approx. 15.1 kg (33.3 lbs)
F30F30A
03 04

Approx. 30 km/h (18.6 mph)
Approx. 40 km (24.9 miles)
Approx. 20%
Asphalt/flat pavement; obstacles < 0.4 in (1 cm); gaps < 1.2 in (3 cm)
-10–40°C (14–104°F)
-10–50°C (14–122°F)
IPX5
Approx. 6.5 h
Certifications
3
Approx. 1143 × 480 × 1160 mm (45 × 18.9 × 45.7 in)
Approx. 1143 × 480 × 495 mm (45 × 18.9 × 19.5 in)
Approx. 15.8kg (34.8 lbs)
Product
Rider
Machine
Battery
Motors
Charger
Features
Tire
Ninebot KickScooter
F40
Approx. 15.9kg (35.1 lbs)
Approx. 25 km/h (15.5 mph)
Item Parameter
Name
Model
Length × Width × Height
Folded: Length × Width × Height
Net Weight
Payload
Recommended Age
Required Height
Max. Speed
Typical Range[1]
Max. Slope
Traversable Terrain
Operating Temperature
Storage Temperature
IP Rating
Duration of Charging
Nominal Voltage
Max. Charging Voltage
Charging Temperature
Nominal Capacity
Nominal Energy
Battery Management System
Output Power
Input Voltage
Max. Output Voltage
Rated Output
Brake Light
Speed Mode
Tire Pressure
Tires
45–50 psi
10-inch pneumatic tires
LED Rear Light
Energy-saving mode, Standard mode and Sport mode
0.07 kW, 70 W
100–240 V~
42 V
41 V , 1.7 A
Nominal Power 0.35 kW, 350 W
36 V
42 V
0–40°C (32–104°F)
10.2 Ah
367 Wh
Over-heating, short circuit, over-current, over-discharge and
over-charge protection
30–120 kg (66–265 lbs)
14–60 years
120–200 cm (3’11”–6’6”)
F40A
[1] Typical Range: tested while riding under full power, 75 kg (165 lbs) load, 25°C (77°F), 60% of max. speed on average on pavement.
* Some of the factors that affect range include speed, number of starts and stops, ambient temperature, etc.
For model: F30 / F40
This product is certified to ANSI/CAN/UL-2272 by TUV Rheinland.
The battery complies with UN/DOT 38.3.
The battery complies with ANSI/CAN/UL-2271.
Federal Communications Commission (FCC) Compliance Statement for USA
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
NOTE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance 20cm between the radiator & your body.
Cet équipement est conforme aux limites d'exposition aux radiations de la IC définies pour un environnement non
contrôlé. Cet équipement doit être installé et utilisé à une distance minimale de 20 cm entre le radiateur et votre corps.
Industry Canada (IC) Compliance Statement for Canada
This device complies with Industry Canada license-exempt RSS standard (s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
CAN ICES-3 (B)/NMB-3(B)
“Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement."
Neither Segway Inc. nor Ninebot is responsible for any changes or modifications not expressly approved by Segway Inc.
or Ninebot. Such modifications could void the user's authority to operate the equipment.
FCC ID: 2ALS8-KS0005
IC: 22636-KS0005
05 06