Nordic TP500S User manual

Simplified Menu Start Up Instructions
Simplified |1

Priming Mode
Your spa will enter Priming Mode when it is connected to power. During Priming Mode
([RUN][PMPS][PURG][AIR]), press “Jet 1” and “Jet 2” button twice to turn pumps on high-speed, to
ensure pumps are free of air. Priming Mode lasts 4-5 minutes or you can exit the Priming Mode by
pressing “Warm” and “Cool” at the same time.
Note: Exiting Priming Mode prior to air being purged from the pumps may cause damage to the pumps
and cause the system to energize the heater to go into overheat condition.
Pump 1 (low-speed) is responsible for heating and filtration and will be referred to simply as the pump.
Low speed pump will run every 30 minutes for 2 to 5 minutes to check the tubs water.
Setting Temperature
The last measured water temperature is constantly displayed.
To change the set temperature, press the “Warm” and “Cool” buttons. Pressing “Warm” or “Cool” will
cause the temperature to flash. When the LCD stops flashing, the spa will heat to the new set
temperature when required.
Setting Time
Setting the time-of-day is important for determining filtration times.
Press the “Menu” button until [TIME/SET] appears on the screen. Use the “Warm” and “Cool” buttons to
adjust the hours. Press “Menu” to complete and move to minutes (15-minute increments). Use the
“Warm” and “Cool” buttons to adjust the minutes. Press “Menu” to complete.
EASY START UP
□Connect Hot Tub to Power
□Allow Pumps to Prime
□Set Temperature
□Set Filter Cycle
Simplified | 2

Filter Cycle
Nordic recommends two filter cycles daily for a total of four hours of filtration per day.
Best Practices: One filter schedule in the morning before morning usage and one filter cycle after nightly
usage.
Press “Menu” until [FLTR] appears on the screen. F12 should be displayed on the right side of the
screen. This indicates there will be 2 filter cycles within 24-hours.
Use the “Warm” and “Cool” buttons to adjust the hours of duration of the filter cycle. Press “Menu” to
complete and move to minutes. Use the “Warm” and “Cool” buttons to adjust the minutes (15-minute
increments) and press “MENU” to complete.
Press “Menu” to go back to the main screen.
If F12 is not displayed – please contact your local Nordic Hot Tubs Authorized Dealer.
Simplified | 3