Nordost BASE User manual

QBASE / QSOURCE STAND MOUNT
Easily support your QBASE or QSOURCE unit with Nordost
Sort Kones, mount it to the wall, or stabilize and lift it
higher o of your floor or rack.
USE WITH:
QSOURCE
QBASE Mark II
QB4
QBASE Mark II
QB6
QBASE Mark II
QB8

ATTACHING STAND MOUNTS:
Unscrew the rubber feet from underneath your
QRT unit, using the provided T10 TORX KEY,
and keep the screws to attach Stand Mounts
in their place.
Note: If you need replacement screws use
M3x0.5x10 (do not exceed 10mm)
41mm / 1.6in
SCREW HOLES FOR
ATTACHING TO UNIT
201mm / 7.9in
SORT KONE DEPRESSIONS /
SCREW HOLES FOR WALL MOUNTING

With the QRT unit on its back, line up the center holes on the
Stand Mounts with the feet holes on either end of the unit.
Screw on, using the T10 TORX KEY (do not over-tighten).
SUPPORTING WITH SORT KONES
Simply arrange four Sort Kones
tip-side up in the depressions
of the Stand Mounts.
Attach Stand Mounts with
the Nordost logo facing the
QRT Unit.
Attach Stand Mounts with
the Nordost logo facing
away from QRT Unit.
For use with Sort Kones: For Wall Mounting or Lifting:
WALL MOUNTING
Use appropriate screws (not included) to
ax unit to wall. Recommended screw size is
M5 or #12 (US).

See www.nordost.com/downloads.php
for more language options