Nortel BayStack 5520-48T-PWR User manual

ERS 5000 Series Installation
Release: 6.0
Document Revision: 04.03
www.nortel.com
NN47200-300
.

Release: 6.0
Publication: NN47200-300
Document release date: 13 April 2009
Copyright © 2008–2009 Nortel Networks
All Rights Reserved.
Printed in Canada
This document contains Nortel confidential and proprietary information. It is not to be copied, disclosed or
distributed in any manner, in whole or in part, without Nortel’s express written authorization. While the information
in this document is believed to be accurate and reliable, except as otherwise expressly agreed to in writing
NORTEL PROVIDES THIS DOCUMENT "AS IS" WITHOUT WARRANTY OR CONDITION OF ANY KIND, EITHER
EXPRESS OR IMPLIED. The information and/or products described in this document are subject to change without
notice.
.

3
.
Contents
Regulatory information and safety precautions 7
International regulatory statements of conformity 7
National electromagnetic compliance (EMC) statements of compliance 7
National safety statements of compliance 11
National Environmental Statements of Compliance 12
Restriction on Hazardous Substances Directive Compliance Statement 12
WEEE Directive Compliance Statement 13
Translations of safety messages 13
Safety messages 13
New in this Release 19
Features 19
Other changes 19
Document changes 19
5600 Series power options 19
Introduction 21
Installation fundamentals 23
Electrostatic discharge prevention 23
Ethernet Routing Switch 5000 series models 24
Common hardware features 27
Universal Serial Bus ports on the Nortel Ethernet Routing Switch 5000
Series 28
Placement options and cables 29
Environmental requirements 29
Placement options 29
Single and multiple switch arrangements 31
Identifying cables to use with the Ethernet Routing Switch 39
Connecting a transceiver to the switch or switch stack 40
Understanding transceiver connections 40
Preparing for power requirements of the switch 42
Nortel Ethernet Routing Switch 5510-24T and 5510-48T 43
Nortel Ethernet Routing Switch 5520-24T-PWR and 5520-48T-PWR 43
Nortel Ethernet Routing Switch 5530-24TFD 44
ERS 5000 Series Installation
NN47200-300 04.03
13 April 2009
Copyright © 2008–2009 Nortel Networks
.

4
5500 Series power options 44
5600 Series power options 46
Ordering the phone dongle 49
Installing the switch 51
Installation tasks 51
Installation Preparation 53
Switch placement 53
Power connection 54
Hardware installation verification 55
Preparations for network connectivity 56
IP address information configuration 57
Stack configuration 58
Procedures for installation of the switch 61
Installation preparation 61
Verifying environment suitability 61
Verifying the contents of the box 64
Switch placement 66
Mounting on a table or shelf 66
Mounting on a wall 68
Installing a front mounted switch in an equipment rack 70
Installing a rear mounted switch in an equipment rack 71
Power connection 73
Installing a power supply module in a 5600 Series switch 73
Connecting an AC cord to switch 74
Installing a redundant power supply in a 5500 Series switch 75
Installing DC-DC converter in a 5500 Series switch 76
Connecting a DC power source to a 5600 Series switch 77
Hardware installation verification 77
Checking LEDs 77
Preparations for network connectivity 81
Cabling a standalone switch 81
Installing transceivers 82
IP address information configuration 83
Connecting a console 83
Accessing the console menu 84
Assigning IP parameters using the console menu 84
Assigning IP parameters using the console menu and NNCLI 85
Assigning IP parameters using the UI button 86
Assigning IP parameters using Web-based Management 86
Verifying assigned IP address is reachable 88
Stack configuration 88
Cabling a stack 89
Selecting a base unit 92
ERS 5000 Series Installation
NN47200-300 04.03
13 April 2009
Copyright © 2008–2009 Nortel Networks
.

5
Selecting a base unit using the UI button 92
Setting non-base units 93
Setting non-base units using the UI button 93
Resetting a stack using the UI button 94
Common procedures 95
Abandoning a command 95
Installation reference 97
RJ-45 connector pin assignments 97
Nortel Ethernet Routing Switch 5510 and 5530 97
Console port pin assignments 98
AC power cord specifications 98
Nortel Ethernet Routing Switch 5520-24T-PWR and 5520-48T-PWR 99
Power specifications 100
Nortel Ethernet Power Supply 10 power specification 100
Nortel Ethernet Redundant Power Supply 15 power specification 100
Nortel Ethernet DC-DC converter module 100
Procedures
Abandoning a command entered using the UI button 95
ERS 5000 Series Installation
NN47200-300 04.03
13 April 2009
Copyright © 2008–2009 Nortel Networks
.

6
ERS 5000 Series Installation
NN47200-300 04.03
13 April 2009
Copyright © 2008–2009 Nortel Networks
.

7
.
Regulatory information and safety
precautions
This module contains the international regulatory statements of conformity
and safety precautions and translations for the Nortel Ethernet Routing
Switch 5500 Series.
International regulatory statements of conformity
This is to certify that the Nortel Networks Ethernet Routing Switch 5500
Series equipment was evaluated to the international regulatory standards
for electromagnetic compliance (EMC) and safety and were found to have
met the requirements for the following international standards:
•EMC - Electromagnetic Emissions - CISPR 22, Class A
•EMC - Electromagnetic Immunity - CISPR 24
•Electrical Safety - IEC 60950, with CB member national deviations
Further, the equipment has been certified as compliant with the national
standards as detailed below.
For regulatory statements of conformity and safety precautions and
translations for the Nortel Ethernet Routing Switch 5600 Series, see
Nortel Ethernet Routing Switch 5600 Series Regulatory Information
(NN47201-101).
National electromagnetic compliance (EMC) statements of
compliance FCC statement (USA Only)
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the Federal Communications
Commission (FCC) rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated
in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy. If it is not installed and used in accordance
with the instruction manual, it may cause harmful interference to radio
ERS 5000 Series Installation
NN47200-300 04.03
13 April 2009
Copyright © 2008–2009 Nortel Networks
.

8Regulatory information and safety precautions
communications. Operation of this equipment in a residential area is likely
to cause harmful interference, in which case users will be required to take
whatever measures may be necessary to correct the interference at their
own expense.
ICES statement (Canada only)
Canadian Department of Communications Radio Interference Regulations
This digital apparatus (Nortel Ethernet Routing Switch 5500 Series)
does not exceed the Class A limits for radio-noise emissions from
digital apparatus as set out in the Radio Interference Regulations of the
Canadian Department of Communications.
Règlement sur le brouillage radioélectrique du ministère des
Communications
Cet appareil numérique (Nortel Ethernet Routing Switch 5500 Series)
respecte les limites de bruits radioélectriques visant les appareils
numériques de classe A prescrites dans le Règlement sur le brouillage
radioélectrique du ministère des Communications du Canada.
CE marking statement (Europe only)
EN 55022 statements
This is to certify that the Nortel Ethernet Routing Switch 5500 Series
equipment is shielded against the generation of radio interference in
accordance with the application of Council Directive 2004/108/EC.
Conformity is declared by the application of EN 55022 Class A (CISPR
22). CAUTION
This device is a Class A product. In a domestic environment,
this device can cause radio interference, in which case the user
may be required to take appropriate measures.
EN 55024 statement
This is to certify that the Nortel Ethernet Routing Switch 5000 Series
equipment is shielded against the susceptibility to radio interference
in accordance with the application of Council Directive 2004/108/EC.
Conformity is declared by the application of EN 55024 (CISPR 24).
EN 300386 statement
ERS 5000 Series Installation
NN47200-300 04.03
13 April 2009
Copyright © 2008–2009 Nortel Networks
.

National electromagnetic compliance (EMC) statements of compliance 9
The Ethernet Routing switch 5500 Series complies with the requirements
of EN 300386 V1.3.3 for emissions and for immunity for a Class A device
intended for use in either Telecommunications centre or locations other
than telecommunications centres given the performance criteria as
specified by the manufacturer.
ERS 5000 Series Installation
NN47200-300 04.03
13 April 2009
Copyright © 2008–2009 Nortel Networks
.

10 Regulatory information and safety precautions
European Union and European Free Trade Association (EFTA) notice
All products labeled with the CE marking comply with R&TTE
Directive (1999/5/EEC) which includes the Electromagnetic
Compliance (EMC) Directive (2004/108/EC) and the Low
Voltage Directive (2006/95/EC) issued by the Commission of the
European Community.
Compliance with these directives implies conformity to the following
European Norms (ENs). The equivalent international standards are listed
in parenthesis.
•EN 55022 (CISPR 22)–Electromagnetic Interference
•EN 55024 (IEC 61000-4-2, -3, -4, -5, -6, -8, -11)–Electromagnetic
Immunity
•EN 61000-3-2 (IEC 610000-3-2)–Power Line Harmonics
•EN 61000-3-3 (IEC 610000-3-3)–Power Line Flicker
VCCI statement (Japan/Nippon only)
This is a Class A product based on the standard of the Voluntary Control
Council for Interference (VCCI) for information technology equipment.
If this equipment is used in a domestic environment, radio disturbance
may arise. When such trouble occurs, the user may be required to take
corrective actions.
BSMI statement (Taiwan only)
This is a Class A product based on the standard of the Bureau of
Standards, Metrology and Inspection (BSMI) CNS 13438, Class A.
MIC notice (Republic of Korea only)
This device has been approved for use in Business applications only per
the Class A requirements of the Republic of Korea Ministry of Information
and Communications (MIC). This device may not be sold for use in a
non-business application.
ERS 5000 Series Installation
NN47200-300 04.03
13 April 2009
Copyright © 2008–2009 Nortel Networks
.