Northcote Pottery SPENCE LETTERBOX User manual

Installation Option A
1) Prepare a level and rm site large
enough to t the width and depth of the
paver. Use a spade to remove any lawn
or other growth.
2) Pour sand into the hole to assist with
levelling and smooth it out
3) Place the paver into the hole and use
a spirit level to ensure its set in a square
position.
4) Drill a hole into the paver to suit
expansion bolts provided.
5) Secure expansion bolt to the
paver using your spanner.
Installation Option B
Follow the steps as per the instillation Option A, but instead of using a
concrete paver and sand prepare a small concrete slab in the hole using
instant cement. The slab should be large enough to t the base of your
letterbox and approximately 40mm in depth. Ensure it is level, and then
once dry follow steps 4-5 above.
Requirements:
You will require the following to install your new pillar letterbox:
• Concrete Paver (large enough to t the base of your letterbox)
• Spade
• Spirit Level
• Screw driver
• Spanner
• Drill
SPENCE LETTERBOX

2. Set your own password by turning dials; ensure the numbers
in the middle row are evenly aligned as shown below.
How to set your combination lock:
The initial password is 0-0-0; to set your own password, please follow these steps:
1. Push the reset button from “A” to “B”.
3. Push the reset button back to “A”. The setting is completed.
SPENCE LETTERBOX