Northeast Color WB00001 Technical manual

Two Persons are
Recommended
for this Installation
Wayback Burger Reverse Clock Sign
PLANNING & INSTALLATION GUIDE
SKU# WB00001-02 | ver. 040723
For Support Call: 603.436.8210

©2023 Northeast Color | 603.436.8210 2
Site Planning
Prior to the sign installation, a single-gang outlet (supplied by others) is to be installed
behind the sign (in accordance with National Electrical Code). Use the drawing below to
plan the sign location. Two Persons are
Recommended
for this Installation
38
34.6
10"
12"
12"
1.5"
10.5"
1"
Safe Area for Single Gang Outlet
Reverse Clock Sign
Second Hand
12v 12w
Power Supply
Screws & Anchors (3)
Self-Tapping Screws (3)
What’s in the Box
Back View Elevation of the Sign
Mounting Bracket

©2023 Northeast Color | 603.436.8210 3
Sign Installation
Two Persons are
Recommended
for this Installation
Pre-Drilled Hole in Wall (7/32")
Wall Anchor (Included)
Screw (Included)
Mounting Bracket (Included)
Single Gang Outlet
(Supplied by Others)
1"
Center & Level Mounting Bracket
Above the Outlet
Single Gang Outlet (Supplied by Others)
Should be Installed Prior to Sign Installation
Mounting Bracket (Included)
Pre-Drilled Hole in Wall (7/32")
Wall Anchor (Included)
Screw (Included)
Mounting Bracket (Included)
Single Gang Outlet
(Supplied by Others)
1"
Center & Level Mounting Bracket
Above the Outlet
Single Gang Outlet (Supplied by Others)
Should be Installed Prior to Sign Installation
Mounting Bracket (Included)
Mount Aluminum Bracket onto the Wall
Center the mounting bracket over the outlet & fasten to the wall.

©2023 Northeast Color | 603.436.8210 4
Plug Power Supply
into the Outlet
Connect the Power
Supply to the Motor
Mount the Second Hand to the Shaft
Twist Clockwise Until Snug
DO NOT OVER TIGHTEN
Second Hand
Sign Installation
Two Persons are
Recommended
for this Installation
Mount Second Hand to Shaft
Twist clockwise until snug (do not over tighten).
Connect Power Supply / Second Hand Inspection
With two persons, attach the power supply to the motor & outlet. Check to make sure the second hand moves freely.
If not, lightly flex it to correct.
Plug Power Supply
into the Outlet
Connect the Power
Supply to the Motor
Mount the Second Hand to the Shaft
Twist Clockwise Until Snug
DO NOT OVER TIGHTEN
Second Hand

©2023 Northeast Color | 603.436.8210 5
Sign Installation
Two Persons are
Recommended
for this Installation
Mount Sign to the Wall
Using the included self-tapping screws, fasten the aluminum enclosure
to the mounted bracket.
Place the Sign Over the
Mounting Bracket
Secure the Sign to the Bracket Using the
Self Tapping Screws
(Included)

©2023 Northeast Color | 603.436.8210 6
Sign Installation
Two Persons are
Recommended
for this Installation
Prior to the sign installation, a single-gang outlet (supplied by others) is to be installed behind the sign (in
accordance with National Electrical Code). Use the drawing below to plan the sign location.
Acrylic Letters
Carefully unpack lettering and remove back film. Be sure that all letters are completely seated to the plastic diffuser
layer and all lines are straight. Make adjustments as needed.
Acrylic Letters
Carefully unpack lettering and remove back film. Be sure that all letters are completely seated to the plastic diffuser
layer and all lines are straight. Make adjustments as needed.
Dynamic
Text Box