10 ENGLISH
DHTS 4022A
Transpondeur : suivez les étapes de la section précédente.
Position No., & Save: The range is from 0 to 63. "0" delegates the original position.
You can select the proper value when you has rotated the antenna.
Go to X: Press OK key to pop up the drop-down list, select the proper position (re-
ference or from 1to 63) to realize the selected position.
West <Save> East: Press key to turn west, while press key to turn east.
Press OK key to pop up the dialogue "Are you sure to change this satellite's posi-
tion?". Press OK key at the Yes button to save the current position, or press OK
key at the No button to cancel the operation.
Recalculation: Press OK key to pop up the dialogue "Are you sure to change this
satellite's position?". Press OK key at the Yes button to recalculation.
5. Limit Setup: Press OK key to pop up the
Limit Setup window.
Limit Setup: Press keys to switch
among Disable Limit, East Limit and West
Limit.
Limit Setup: Move cursor to the Limit Setup
button. You can press key to turn west ,
or press key to turn east.
Go to Reference: Press OK key to go to refe-
rence. If you select Disable Limit in the above
Limit Setup item, this button will turn grey.
6. If select USALS, Delete All item will turn grey.
Local Longitude, Local Latitude: Press keys to switch between West and
East, or press keys to switch between North and South. Press OK key to
enter into the editing mode. Use numeric keys (0-9) to input the longitude or lati-
tude, press MENU key or EXIT key to exit. The range of the longitude is from 0 to
180,while the range of the latitude is from 0 to 90. If the inputted value is not in
this range, system will pop up a dialogue "Out of Range" when you exit from this
window. You can press OK key to close this
7. Motor Setting: Press OK key to enter into the Motor setting window.
Satellite, Transponder: Press keys to select satellite or transponder, or
press OK key to pop up the drop-down list and select in the list.
2.4 Single Satellite Search
1. Satellite : Press keys to select the satellite in circle. Or press OK key to
pop up the drop-down list, then select the desired satellite in the list and press OK
key to confirm.
2. FTA Only: Press keys to select between Yes and No.
3. Scan Channel: Press keys to select among TV+Radio, TV Channel, Radio.
4. Network Search: Select between No and
Yes. This item turns grey when Auto Scan is
selected in the following Scan mode item.
5. Scan Mode: Press keys to select
between Auto Scan and Preset Scan. Auto
Scan is lind scan, while Preset Scan is to se-
arch the preset frequencies.
6.Turner: LN 1
7. Search: Press OK key to start searching.
2.5 Multi Satellite Search
From the Multi Satellite Search window, you can search several satellites at the
one time.
1. Satellite: All selected satellites in the satellite
list window are displayed on the down part.
You can press keys to switch among
them.
2. FTA Only: Press keys to select bet-
ween Yes and No.
3. Scan Channel: Press keys to select
among TV+Radio, TV Channel, Radio.
4. Network Search: Select between No and
Yes. This item turns grey when Auto Scan is
selected in the following Scan mode item.
5. Scan Mode: Press keys to select between Auto Scan and Preset Scan.
Auto Scan is lind scan, while Preset Scan is to search the preset frequencies.
6.Turner: LN 1
7. Search: Press OK key to start searching.
