NRS Relief DomeHome User manual

DomeHome
UNHCR standard – self-standing family tent
230, inner 429
430, inner 420
100
75
233
inner 225
193
inner 183
70
Front view
100
430
Rear view
100
430
Top view Side view
430
430
430
193 233
Side view Plane view
550
550
550
A1x Outer tent (guy lines pre-installed)
B1x Inner tent (pre-installed)
C1x Inner partition (pre-stitched in inner tent)
D2x Grey poles (crossing arches)
E1x Orange pole (middle arches)
F2x Blue poles (front and back arch)
G1x Green pole (ridge pole)
H1x Shade cover (guy lines pre-attached)
I14x J-pegs 30 cm length
J6x T-pegs 40 cm length
K1x Repair kit
L1x Hammer
M1x Assembly Manual
Packing list
Ideal to assemble
this tent.
Technical drawing
(All measurements in cm)
1
PEGS
POLES
ACCESSORIES
i
ii
iii
(i) Unpack the package and take aside the bags with
poles and accessories. (ii) Remove the bag.
(iii) Unroll the bundle.
Min. 6 m
Min. 9.5 m
Place the package at the exact place where the tent will
be erected.
1 2
Firmly join the colour-coded sections together.
3
A
D
Slide the colour-coded poles through their
respective sleeves.
4
Grey pole - cross pole
Orange pole - middle pole
Green pole - ridge pole
Push the tent upwards from inside at the middle while
inserting grey poles and orange poles into the tips of
the base plates.
5
Slide the blue front and back arches through the
sleeves and insert the tips of the poles into the base
plates.
6
F
D
E
D, E, F& G
G
E
Watch the assembly video online:
nrsrelief.com/products/domehome/
2

Assembly instructions
Wrap all Velcro straps around the respective poles.
7
Pull out the corners to tension the groundsheet. Secure
base plates with, J-pegs (I).
9
Secure the base of the tent with J-pegs.
Secure the green pole to the middle of the blue pole
using the clip on both sides of the tent.
10
If possible, dig a trench and bury and fill the mudflap
with stones, dirt and rocks.
11
1: Use large T-pegs (J) to secure the four main
corner ropes.
2: Use J-pegs (I) to secure the other ropes.
12
8
UNHCR standard – self-standing family tent
3
Outer tent
Poles
Inner tent
Mesh Windows
Attach the shade net to the blue poles in the tent
using Velcro loops.
14
DomeHome Assembly instructions
1: Place the shade cover (H) on top of the tent and close
Velcro straps to position shade net.
2: Tie the remaining guy ropes to the pegs.
13
1
2
Tear
Cover hole with PE Fabric patch and stitch to
outer tent with needle thread. Stick duct tape over
the seams to make them waterproof.
Cover with duct tape
on both sides. 1. Needles
2. Thread
4. Duct Tape
5. PE Fabric
Hole
Pole crack
Straighten pole and slide repair
sleeve over break.
Fix repair
sleeve in place
with duct tape.
4. Duct tape
Tear
1. Needles
1. Needles
2. Thread
2. Thread
1. Needles
1. Needles
2. Thread
2. Thread
6. Mesh
6. Mesh
Hole
Cover hole with
Mesh patch and
stitch with needle
+ thread.
Cover hole with
PE Fabric patch
and stitch with
needle + thread.
Repair tear with
needle + thread.
Repair tear with
needle + thread.
3. Repair
sleeve
2 x Needles Thread 3 x Repair Sleeve Duct Tape PE Tape Mesh
1 2 3 4 5 6
Repair manual
4