GeoHome - ICRC/IFRC standard - family tent
Sleeves
Pole
1
6
11
2
7
12
16
3
8
13
17
Layout the outer tent.
Insert the other end of each pole into the eyelet of
the base plate at the other end of the pole sleeve.
Place candy cane pegs into the loops next
to the entry doors.
Connect the shade cover to the tent by closing the
velcro straps over the Velcro on the pole sleeves.
Assemble all pipes.
Slide the sloped poles through the short pole
sleeves above the doors.
Stake out a long T-peg 1.5 m from each of the six
corners and connect the guy lines.
Connect the guy lines of the shade cover to the snap
hooks on the T-pegs and tighten.
Slide three cross poles through the sleeves. Ensure
that all poles go through the central red loop.
Fix the ends in the three-pole base plates at the
sides of the tent.
Connect the buckles of the partition, starting at the
centre with the red strap, and then the remaining
buckles.
Fill pockets of mud-aps with stones, dirt, rocks.
Insert one end of each pole into the eyelet of the
base plate at the one end of the pole sleeve.
Wrap all velcro straps around the crossing poles.
Complete by connecting the remaining buckles
Erect the tent by pushing the poles into sleeves.
Wrap all velcro straps around the sloped poles.
Place the shade cover on top of the tent.
x 3
T-peg
1.5m
4
9
14
18
5
10
15
F
E
