NSA W-RCWS1-SS User manual

Safety Instructions
WARNING - This appliance is intended for use in
a domestic environment.
When using electrical appliances, basic safety precautions
should always be followed:
1. Check the household voltage to ensure it matches the
appliance’s rated specification.
2. Extreme care should be taken when any product is used by, or
near children or individuals with certain disabilities. eep out of
reach of children when not in use.
3. Before operating your Corkscrew/Preserver remove the unit
from its packaging and charge the unit for at least 16 hours.
4. Never force the corkscrew onto a bottle or attempt to speed
up the mechanism. The Corkscrew will work best at its intended
speed.
5. Do not let children play with the packaging, for example the
plastic bags.
6. Do not operate any product with a damaged cord or plug.
7. Do not attempt to open bottles if the switch is not working
correctly.
8. If your Corkscrew/Preserver malfunctions or is damaged in any
manner return the Corkscrew to an authorised service facility
for examination and repair to avoid a hazard.
9. Do not attempt to repair or adjust any electrical or mechanical
functions on this unit as this may void warranty.
10. Always unplug the charger if you do not intend to use your
Corkscrew/Preserver for a long period. To disconnect from the
power supply, grip the adaptor and pull from the power socket.
Never pull by the cord.
11. This product is not intended for use in wet or damp locations.
12. Do not let the power cord hang over the edge of a table or
counter. Arrange the power cord away from any area where
it may be tripped over.
13. Never place the Corkscrew/Preserver or charger where it may
fall into a sink or other water container.
14. When not in use always store in a dry area.
15. Do not place the unit in a dish washer.
16. Do not place the corkscrew on or near an open flame, cooking
or heating appliance or a hot surface.
17. Use only with the adaptor supplied.
18. This product contains no serviceable parts.
Technical Information
Model No: W-RCWS1-SS
Manual Ref: IM/W-RCWS1-SS/1734
Battery Type: Ni-MH, rechargeable, AAA size
Voltage: 3.6V (3 batteries of 1.2V each appliance)
Adaptor Input: 100-240V; AC 50/60Hz 0.5A Max
Adapter Output: 6V DC, 80mA
Adaptor Ref: YLJXA-U060008
1
st
Charging Time: 16 hours (thereafter 10hrs)
Product Dims 29 (H) x 10 (W) x 17 (D) cm (on stand):
Product Weight: NW: 1.02 kg / GW: 1.35 kg
Battery & isposal Information
♦This Corkscrew contains rechargeable batteries. Before you
dispose of your Corkscrew you must remove the batteries and
dispose of them responsibly.
♦To take out the battery pack,
remove the screws from the
rear cover.
♦Carefully ease the two covers
apart, please note, there are
springs inside your Corkscrew
that will move once the covers
are parted but normally stay
inside the product.
♦Unplug the leads from the battery pack (Fig 6) and remove it
from your Corkscrew.
♦Dispose of the rechargeable battery pack and product
responsibly.
♦Do not mix products bearing the crossed out bin
symbol with your general household waste.
♦For the correct collection and treatment of these products
take them to collection points designated by your local
authority. Alternatively, contact the store which sold you the
product.
Rechargeable Lithium-ion Battery Warnings
♦The rechargeable Lithium-ion battery contained in this
product may explode if disposed of in a fire.
♦Do not charge the battery used in this equipment with any
other charger than the one provided with the product. Using
another charger may damage the battery or cause the
battery to explode.
♦This product is not waterproof. To reduce the risk of fire,
electrical shock or damage, DO NOT expose the unit to rain
or moisture.
Service & Warranty
♦This product is guaranteed free from defects in materials and
workmanship for a period of one (1) year. Proof of purchase
is required to validate the guarantee.
♦Should this unit be operated under conditions other than those
recommended, at voltages other than the voltage indicated
on the unit, or any attempts made to service or modify the
unit, this will render this WARRANTY VOID.
♦This guarantee is no longer valid if the damage has been
caused by fall, alteration or repair by any unauthorised
persons or if the product has been resold.
♦The product you buy may sometimes differ slightly from
illustration.
♦This warranty is in addition to, and does
not affect, your statutory rights.
♦Should you have a problem with this
product, please contact our help desk
on tel: [phone].
♦This product has been manufactured
to comply with EMC Directive
2004/108/EC.
© 2017 Newton Stovold Assocs Ltd
[e-mail]/electrical * GU8 6AA
2-in-1 Rechargeable
Corkscrew & Wine
Preserver Gift Set
Model No: W-RCWS1-SS
Stainless Steel Finish
Rechargeable Corkscrew & Wine Preserver in One
16hrs to charge battery full (1st charge, thereafter 10hrs)
Opens 30 bottles with real corks
or seals 50 bottles – when fully charged
Blue LED lights illuminate when charging & in use
Wine aerator – to prevent drips when pouring
2 x silicone stoppers w. date indicator
Foil cutter
Charging adaptor & display/storage stand
Please read this instruction manual
before using your Corkscrew/Preserver
for the first time & keep safe
for future reference.
www.nsauk.com/electrical
Fig. 6

Operating Instructions
We recommend charging the Corkscrew/Preserver for at
least 16 hours before first use. Please follow the instructions
below.
CAUTION: For your own safety and the functioning
of the corkscrew – O NOT put fingers or objects
near the spiral, especially when in use.
CAUTION: Use only the charger supplied with this
product as using another charger may damage the
rechargeable battery installed in this unit or cause
the battery to explode.
Charging your corkscrew & preserver
1. Plug one end of the adapter cord into the charging base
and the other end into a wall socket.
2. Place the wine opener end into the charging base,
making sure that it is firmly in position and is fully engaged
with the recharging connectors.
Note: The wine opener will only fit into the charging base
one way. The blue light turns on when the unit is seated
properly, the charging base is connected in a wall socket,
and the unit is charging. The light turns off when the
opener is fully charged.
♦It takes about 16 hours to fully charge your wine opener
for the first time, thereafter c. 10hrs.
♦When fully charged, it can to open approximately
30 bottles (or seal 50 bottles).
♦You should leave the adapter connected and the
appliance on the charging base to maintain a full
charge.
Operating Process - Corkscrew
Step 1: Remove the foil cap from the
wine bottle with the included foil cutter
before using the corkscrew. (Fig. 1)
Step 2:
1. Hold the wine bottle with one hand
and place the electric corkscrew
onto the wine bottle.
2. Hold bottle firmly with other hand to
prevent it spinning round.
3. Press the “DOWN” button to remove
cork from the bottle. (Fig. 2)
4. The unit will stop once the cork is
removed.
Step 3:
1. Move the corkscrew away from the
bottle.
2. Press the “UP” button to eject the
cork from the wine opener. (Fig. 3)
After Use
♦We recommend that you return
your Corkscrew/Wine Preserver to
the stand, so that it is fully charged
and available to use at any time.
Understanding the wine preserver
♦By removing the oxygen from the bottle, the wine
preserver prevents the early oxidation of the wine, which
dulls and damages the taste of the wine (red wines
especially).
♦The 2-in-1 wine opener and preserver is provided with two
special wine stoppers that will keep the air from
re-entering the bottle after using the wine preserver. The
stoppers always need to be used in conjunction with the
wine preserver.
♦The wine stoppers are equipped with a silver ring that lets
you indicate the date the wine preserver was last used,
and keep track of the time the bottle has been opened.
♦We recommend drinking the contents of an opened
bottle within three to five days to preserve its qualities.
Using the wine preserver
1.
Place the wine bottle on a flat surface.
Insert a wine stopper into the wine bottle.
2. Hold the wine stopper & wine bottle neck
securely in one hand and place the Wine
Preserver on the wine stopper.
3. eep the Wine Preserver as straight as
possible and in line with the wine bottle.
Use your thumb and forefinger of the
hand holding the bottle to steady the
Wine Preserver.
4. Push down on the wine stopper. This
activates the pump, which gradually
removes the air from the bottle while the
stopper prohibits air from re-entering the bottle (Fig. 4).
5. The pumping noise will become slower and stop
suddenly after c. 15-20 secs.
6. Do not release the pressure on the wine stopper until the
unit stops.
7. Remove the Wine Preserver and replace on its stand
until it is needed again.
8. After sealing the wine bottle, store in an upright position
as wine may leak if the bottle is laid on its side.
Note 1: The Wine Preserver may attach itself to the wine
stopper. In this case, hold the wine stopper and the neck
of the bottle securely in one hand then tilt the Wine
Preserver away from the wine stopper to break the
suction. This should prevent air from re-entering the bottle.
If in doubt, repeat the above operating process.
Note 2: There is no need to use the power button when
using the Wine Preserver – firm, downward pressure only.
The blue light will glow when the unit is operating.
Suggestion: For more than half a bottle of wine remaining
– one session should suffice. For less than half a bottle we
suggest you repeat the above process a 2nd time.
ate Indicators
1. Use the “ ▼ ” symbol on the stoppers
to indicate the date when the bottle
was sealed with your Wine Preserver.
2. Gently swivel the silver ring to left or
right until the correct date is in line
with the “ ▼ ” symbol (Fig.5).
Opening a bottle sealed with a stopper
♦Firmly hold the bottle in one hand and gently ease the
wine stopper away from the bottle with your thumb.
♦Store the wine stoppers on the charging stand or in a
clean safe place until next required.
♦Rinse the stoppers occasionally in warm soapy water –
ensure they are dry before storing or using.
♦Do not place in a dishwasher.
Note: You can remove th e vacuum in the bottle also by
pressing the pin at the centre of the wine stopper to the side.
If the bottle was sealed recently you should hear the air
re-entering the bottle.
Cleaning
1. Never immerse the appliance in water.
2. To clean the outer surface, simply wipe with a damp
cloth.
3. Do not use any scouring pads or abrasive cleaners as
these will result in scratches to the unit.
4. Do not use any chemical-based solutions on this product.
5. Ensure the unit is completely dry before storage or
reconnecting to electrical supply.
Recycling & isposal
The packaging of your new wine preserver has
a recycle mark on it. Please dispose of it as
recycled paper or by using the “Dual System”.
Please Recycle
Fig. 1
Fig. 2
Fig. 3
Fig. 5
Fig. 4