7 8
USAGE - SMALL AND LARGE SPONGE BRUSH HEADS
NOTE: It is recommended to exfoliate your skin 2 times a week. Use it to
get rid of the dead skin cells. For all skin types. Do not share brush heads.
1. Make sure that your skin is clean prior to exfoliating. If it is not,
wash your face using your cleanser and Nu Brilliance with Facial
Brush Head Attachment. Follow the directions on p. 6. Make sure
to remove the Facial Brush Head attachment afterwards.
2. Select the appropriate attachment (Small Sponge Brush Head
for face or the Large Sponge Brush Head for body).
Refer to pp. 4 and 5 for attachment selection and kit assembly.
3. Wet your face with warm water. Apply the exfoliator to your
skin in a circular motion. Do not use harsh, grainy exfoliators.
4. Wet the attachment of the Nu Brilliance foam brush in warm
water. Turn the foam brush on by pressing on the Power button.
Press it once for low speed, press it again for high speed.
We recommend to start at the low speed. Once your skin
becomes comfortable, you may increase the speed.
To turn the unit o, press the Power button again.
5. Gently move the foam brush in circular motion over the skin for approximately 60 seconds.
Keep foam
brush head ush to the skin, but do not press too hard. Make sure to avoid
delicate eye area. Turn it o when done. Rinse face with water. Pat the skin dry and apply
your usual moisturizer and/or serum.
USAGE - SMALL & LARGE SPONGE BRUSH HEAD
USAGE - PUMICE BRUSH HEAD
NOTE: Can be used on wet or dry skin. Use it on cracked or dry feet or anywhere else to bu away
dry skin. Do not share brush heads.
1. Make sure that your skin is clean prior to exfoliating.
2. Select the Pumice Brush Head Attachment. Refer to pp. 4 and 5 for attachment selection and kit
assembly.
3. Wet the area with warm water (or you can keep it dry).
4. Wet the attachment of the Nu Brilliance foam brush in warm water. Turn the pumice brush on by
pressing on the Power button. Press it once for low speed, press it again for high speed.
We recommend to start at the low speed. Once your skin becomes comfortable, you may increase
the speed. To turn the unit o, press the Power button again.
5. Gently move the pumice brush in circular motion over the skin. Keep pumice brush head ush to
the skin, but do not press too hard. Turn it o when done. Rinse the area with water. Pat it dry and
apply a little lotion to help hydrate the area and prevent aggravating dry skin.
6. Rinse the pumice brush head under running water. Store it with the brush head attachment up.
Let it dry naturally.
IMPORTANT: If the condition of your skin worsens after one or several uses of Nu Brilliance,
give
your skin a rest for a few days. Always start at the low speed and progress to high speed if needed,
depending on your comfort level and skin sensitivity. If you are concerned about any change in
your skin condition, consult your dermatologist.
USAGE - PUMICE BRUSH HEAD
SMALL
LARGE
6. Rinse the foam brush head under running water. Store it with the brush head attachment up.
Let it dry naturally.
IMPORTANT: If the condition of your skin worsens after one or several uses of Nu Brilliance, give
your skin a rest for a few days. Always start at the low speed and progress to high speed if needed,
depending on your comfort level and skin sensitivity. If you are concerned about any change in
your skin condition, consult your dermatologist.
4. Gently move the brush in circular motion over the skin for approximately 60 seconds. Keep brush
head ush to the skin, but do not press too hard. Make sure to avoid delicate eye area. Turn it o
when done. Rinse face with water. Pat the skin dry and apply your usual moisturizer and/or serum.
5. Rinse the brush head under running water. Store it with the brush head attachment up.
Let it dry naturally.