NUMARK INDUSTRIES COMPANY SC-160NERC/3 User manual

SICILY 3 PC CUSHION ROCKER SET
ASSEMBLY INSTRUCTIONS
ITEM# SC-160NERC/3
QUESTIONS, PROBLEMS, MISSING PARTS WITH THIS PRODUCT? DO NOT
RETURN TO YOUR RETAILER, PLEASE CALL OUR CUSTOMER SERVICE
DEPARTMENT 9:00 A.M. TO 5:00 P.M. EASTERN STANDARD TIME MONDAY
THROUGH FRIDAY PHONE# [phone]

SICILY 3 PC CUSHION ROCKER SET
ASSEMBLY INSTRUCTIONS
ITEM# SC-160NERC/3
1) Remove all components from the polybag and unwrap all package materials. Place
them on a flat surface. Please count the components, there are:
a) 4 arms (A)
b) 2 seats (B)
c) 2 back decoratives (C)
d) 2 cushions (D)
e) 1 tabletop (E)
f) 1 metal center ring (F)
g) 3 metal legs (G)
h) One accessory bag consists of 4 short bolts (Ha) plus 1 spare, 7 medium bolts
(Hb) plus 1 spare, 8 long bolts (Hc) plus 1 spare, 7 metal washers (Hd) plus 1
spare, 12 metal sleeves (He), 1 Allen wrench (Hf), 1 assembly instructions
sheet (Hg), 12 bolt caps (Hh) plus 1 spare.
CUSHION ROCKING CHAIRS ASSEMBLY
2) Attach the back decorative (C) to the seat (B),
align the holes on the back decorative with
the holes on the rear crossbar of the seat.
(Note: The “FRONT” sticker is towards the
front.) For each hole insert a short bolt (Ha)
through a metal washer (Hd), through the
back, and secure into the rear crossbar.
Don’t tighten completely. See Fig. 1.

SICILY 3 PC CUSHION ROCKER SET
ASSEMBLY INSTRUCTIONS
ITEM# SC-160NERC/3
3) Attach the arms (A) to the assembled seat and
back, insert the connectors of the back and
seat into the sleeves of the arms (A). Align the
holes, for each hole insert a long bolt (Hc)
through a metal sleeve (He), through the arm
(A), secure into the crossbar of the seat (B).
Don’t tighten completely. See Fig.2. Repeat
procedure for the top crossbar with two medium
bolts (Hb). See Fig. 3.
4) Tighten all bolts by using the Allen wrench (Hf)
and cover with bolt caps (Hh) where necessary.
5) Put the cushion (D) on and wrap the Velcros on the
chair frame. Repeat procedure for the other chair.

SICILY 3 PC CUSHION ROCKER SET
ASSEMBLY INSTRUCTIONS
ITEM# SC-160NERC/3
SIDE TABLE ASSEMBLY
6) Insert three metal legs (G) into three plastic receivers on the tabletop (E), working
the leg in until the holes in legs and receivers line up.
7) Place the metal center ring (F)
between the three legs. Align the
holes, for each hole insert a
medium bolt (Hb) through a
metal washer (Hd), through the
metal center ring (F) and secure
into the metal leg (G). Do not
tighten. See Fig. 4.
8) Tighten all bolts by using the Allen
wrench (Hf) and turn the table over.
Your cushion chairs and table are now ready for use.
NUMARK INDUSTRIES COMPANY LTD.,
PRINTEDINCHINA