NVI SOLARIS PAPER D67011 User manual

SP-DSP-I107-0315
Top-Down Bath Tissue Dispenser
Dispenser Numbers:
D67011 Manual Bath Tissue Top-Down Dispenser (Stainless)
D67012 Manual Bath Tissue Top-Down Dispenser (White)
D67013 Manual Bath Tissue Top-Down Dispenser (Black)
Loading Instructions
For dispenser questions contact Customer Service at: 1 [phone] or dispen[email protected]
Step 1 –
Using key –open
front cover. Slide
the carriage out the
top of the
dispenser track.
Step 2 –
Unsnap and rotate the side
arms of the carriage to load
new rolls of LoCor® toilet
paper.
Step 3 –
Slide the new rolls of LoCor® toilet
paper onto the carriage spindles.
Be sure that when loading the
bottom roll of paper, that the roll
diameter sensor is rotated out of
the way of the roll of paper.
Step 4 –
Rotate the
carriage side
arms back toward
the closed
position and snap
closed.
Step 5 –
Slide the carriage, loaded
with LoCor® toilet paper,
back into the top of
dispenser track. Be sure
that the roll diameter sensor
is on the bottom and toward
the back.
Step 6 –
Close the cover.
The toilet paper is now
ready to dispense.
Roll Diameter Sensor
Spindle
Side Arms

SP-DSP-I107-0315
Mounting Instructions
Tools:
Screwdriver
Power Drill with appropriate drill size
Pencil
Level
Step 1 –(refer to Fig. 1)
Measure a minimum of 17.5” minimum from the floor to the bottom of the dispenser.
Step 2 –(refer to Fig. 2)
Drill a pilot hole for the first screw. Fasten the screw to the wall, leaving a gap between the screw and the
wall for the dispenser to slide over.
Step 3 –(refer to Fig. 2)
Place a level at the bottom of the dispenser to insure dispenser mounting will be correct. Mark the additional
3 mounting holes. Remove dispenser and drill pilot holes.
Step 4 –
Re-hang the dispenser on the installed screw. Fasten remaining 3 mounting screws. Be sure to securely
tighten all screws.
Please use the appropriate hardware for the wall material the dispenser is to be mounted to.
Note: Mount according to ADA Guidelines, installer is responsible for compliance.
For dispenser questions contact Customer Service at: 1 [phone] or dispen[email protected]
17.5”
Fig. 1
Fig. 2
Pilot Hole
(Step 2)
3 Additional Holes
(Step 3)
Place Level Here
(Step 3)