Nyce NCZ-3014-HA User manual

GARAGE DOOR (TILT) SENSOR
INSTALLATION GUIDE
STEP 1: INSTALL BATTERY
Slide open the Garage Door
Sensor’s top housing. Install the
CR2032 battery in the housing top
as shown below.
STEP 2: JOIN THE NETWORK
Users:
Refer to the instructions on your web portal or
smart phone application to join and configure the
Garage Door (Tilt) Sensor.
Developers:
Refer to NYCE’S “ZigBee Device Messaging
Specification” document for details on how to join
the Garage Door (Tilt) Sensor to the ZigBee
network.
This document can be found on NYCE’s Website
Support page: www.nycesensors.com/support/
STEP 3: PROPER DEVICE ORIENTATION
Mount the Garage Door Sensor on a horizontal pane of the garage door.
The Sensor should be mounted on the top pane (fully closed) or bottom
pane (fully open), depending on the desired operation. A pair of
sensors can be used on both bottom and top panes for full garage door
reporting, if desired.
Ensure that the Garage Door Sensor is oriented with the bar symbol
vertical, parallel to the edge of the garage door, as shown in the
diagram below on the left.
INCORRECT ALIGNMENT
CORRECT ALIGNMENT
Button
Garage Door Sensor
Right edge of Garage Door
Right edge of Garage Door

STEP 4: TEST THE SENSOR
Test the Sensor from the desired location before
permanently installing it by flipping it forward as
shown above, this is the same action as the garage
door opening.
Check that the Sensor is reporting a Closed or
Open message from both orientations.
STEP 5: INSTALL THE SENSOR HOUSING
Using the methods shown below, install the Garage Door Sensor
bottom housing on a clean surface.
OPTION 1: 2-SIDED TAPE OPTION 2: SCREWS
Notes: Installation on metal surfaces can reduce transmission range.
Ensure that the device is installed in a dry location away from
water, moisture and rain.
STEP 6: INSTALL THE SENSOR
Once you have installed the bottom
housing and confirmed the device is
communicating, insert the sensor top
housing as shown above
PRODUCT FUNCTION AND LED INDICATORS
BUTTON LED ACTION LED DESCRIPTION
2 TIMES  NETWORK STATUS  JOINED
 NOT JOINED
 RE-JOIN IN PROCESS
4 TIMES  NETWORK JOIN SEARCHING FOR NETWORK
DEVICE BEING CONFIGURED
 DEVICE JOINED
 DEVICE FAILED TO JOIN
8 TIMES  FORCED RE-JOIN  RE-JOIN, SEARCHING FOR PARENT
10 TIMES  NETWORK LEAVE  LEAVE (IF JOINED) AND
AND DEFAULT  DEFAULTS RESTORED
NO ACTION WRONG BUTTON PRESS
DEVICE BUSY
POWER UP 
Button
LED