Nyce NCZ-3041 User manual

MOTION SENSOR
INSTALLATION GUIDE
STEP 1: INSTALL BATTERY
To open the
battery cover,
use a
flathead
screwdriver in
the recessed
Te h slot as shown.
Remove the packing tape, if present,
from the battery cover and install the
CR2 battery with polarity as shown.
If the battery is pre-installed, simply
remove the plastic pull tab.
STEP 2: INSTALL DRIVER AND IDENTIFY
Install the device’s driver: MotionSensor_zb_nyce_3041.c4i
Download driver from: www.nycesensors.com/support
or from Control4’s online database
Copy to My Documents\Control4\Drivers
Open Composer and add device to project (Manufacturer = “NYCE”)
Identify the device by pressing the button 4 times while its identify
window is open.
The device’s 64-bit address should appear in the identify window’s text
box.
STEP 3: VERIFY DEVICE AND CLOSE
Verify that the device is sensing motion.
The sensor requires a 3 minute “warm-up” time
before it will report motion.
The LED should flash red and motion should be
indicated in Navigator or Composer’s List View.
Snap the battery cover into place.

STEP 4: PLACEMENT GUIDELINES
Orient the Motion Sensor for best use of its detection
zones.
* All Measurements are approximate.
STEP 5: INSTALL THE MOTION SENSOR
Install the Motion Sensor on a clean surface using the 2-
sided tape provided. It can be installed on a flat surface
or in a corner, vertically, horizontally or upside down.
Notes: Test the Sensor from the desired location before
permanent installation. Installation on metal can reduce
transmission range. Ensure that the device is installed in
a dry location away from water, moisture, and rain.
READING AND WRITING ATTRIBUTES
To Read:
In Composer, under the Actions tab, click on
Read Attributes. Wake up the device by
triggering motion or with a double button press.
Check the updated attribute value under the
Properties tab. The Attribute Status field
should read: “Attributes are up to date.”
To Write:
In Composer, change the attribute value
(Custom = 4 - 65535 seconds) under the
Properties tab and click Set.
Under the Actions tab, click on Write Attributes.
Wake up the device by triggering motion or
with a double button press.
Check the Attribute Status field. It should read:
“Attributes are up to date”.
PRODUCT FUNCTION AND LED INDICATORS
BUTTON LED ACTION LED DESCRIPTION
2 TIMES  NETWORK STATUS  JOINED
 NOT JOINED
4 TIMES  NETWORK JOIN SEARCHING FOR NETWORK
DEVICE BEING CONFIGURED
 DEVICE JOINED
 DEVICE FAILED TO JOIN
6 or 10  or NETWORK LEAVE  LEAVE (IF JOINED) and
TIMES  and DEFAULT  DEFAULTS RESTORED
NO ACTION WRONG BUTTON PRESS
 NETWORK ERROR, RETRY
 DEVICE BUSY
MOTION DETECTED 
POWER UP 