STEP 4: VERIFY DEVICE
LED
Verify that the device is sensing motion. The
sensor requires a 3 minute “warm-up” time
before it will report motion.
The LED should flash red and motion should be
indicated on your web portal or smart phone
application.
STEP 5: PLACEMENT GUIDELINES
45°
Ceiling
Height
Coverage 8’
Radius
8’
10’
10’
12’
12’
Position the Ceiling Motion Sensor for best use of its
detection zones.
* All measurements are approximate and will vary
with installation.
STEP 6: INSTALL THE SENSOR
Install the Mounting Plate on an overhead surface using
the two #6 screws provided. Place the Sensor Housing
over the Mounting Plate, there is no “keyed” location.
Rotate the Housing clockwise to lock it into place.
Notes: Installation on metal can reduce transmission
range. Ensure that the device is installed in a dry location
away from water, moisture, and rain.
PRODUCT FUNCTION AND LED INDICATORS
BUTTON LED ACTION LED DESCRIPTION
2 TIMES NETWORK STATUS JOINED
NOT JOINED
RE-JOIN IN PROCESS
4 TIMES NETWORK JOIN SEARCHING FOR NETWORK
DEVICE BEING CONFIGURED
DEVICE JOINED
DEVICE FAILED TO JOIN
8 TIMES FORCED RE-JOIN RE-JOIN, SEARCHING FOR PARENT
10 TIMES NETWORK LEAVE LEAVE (IF JOINED) AND
AND DEFAULT DEFAULTS RESTORED
NO ACTION WRONG BUTTON PRESS
DEVICE BUSY
MOTION DETECTED
POWER UP
LED
BUTTON
