Nyce NCZ-3041-HA User manual

MOTION SENSOR
INSTALLATION GUIDE
STEP 1: INSTALL BATTERY
To open the
battery cover,
use a
flathead
screwdriver in
the recessed
Te h slot as shown.
Remove the packing tape, if present,
from the battery cover and install the
CR2 battery with polarity as shown.
If the battery is pre-installed, simply
remove the plastic pull tab.
STEP 2: JOIN THE NETWORK
Users:
Refer to the instructions on your web portal or smart phone application
to join and configure the Motion Sensor.
Developers:
Refer to NYCE’S “ZigBee Device Messaging Specification” document for
details on how to join the Motion Sensor to the ZigBee network.
This document can be found on NYCE’s Website Support page:
www.nycesensors.com/support/
STEP 3: VERIFY DEVICE AND CLOSE
Verify that the device is sensing motion.
The sensor requires a 3 minute “warm-up” time
before it will report motion.
The LED should flash red and motion should be
indicated on your web portal or smart phone
application.
Snap the battery cover into place.

STEP 4: PLACEMENT GUIDELINES
Orient the Motion Sensor for best use of its detection
zones.
* All Measurements are approximate.
STEP 5: INSTALL THE MOTION SENSOR
Install the Motion Sensor on a clean surface using the 2-
sided tape provided. It can be installed on a flat surface
or in a corner, vertically, horizontally or upside down.
Notes: Test the Sensor from the desired location before
permanent installation. Installation on metal can reduce
transmission range. Ensure that the device is installed in
a dry location away from water, moisture, and rain.
READING AND WRITING ATTRIBUTES
Users:
Refer to the instructions on your web portal or
smart phone application to configure the
attributes of the Motion Sensor.
Developers:
Refer to NYCE’S “ZigBee Device Messaging
Specification” document for details on how to
configure and read the attributes of the Motion
Sensor through the ZigBee network.
This document can be found on NYCE’s Website
Support page: www.nycesensors.com/support/
PRODUCT FUNCTION AND LED INDICATORS
BUTTON LED ACTION LED DESCRIPTION
2 TIMES  NETWORK STATUS  JOINED
 NOT JOINED
 RE-JOIN IN PROCESS
4 TIMES  NETWORK JOIN SEARCHING FOR NETWORK
DEVICE BEING CONFIGURED
 DEVICE JOINED
 DEVICE FAILED TO JOIN
8 TIMES  FORCED RE-JOIN  RE-JOIN, SEARCHING FOR PARENT
10 TIMES  NETWORK LEAVE  LEAVE (IF JOINED) AND
AND DEFAULT  DEFAULTS RESTORED
NO ACTION WRONG BUTTON PRESS
DEVICE BUSY
MOTION DETECTED 
POWER UP 