FCC WARNING
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC CAUTION:
Any changes or modications not expressly approved by the party responsible for compliance could void the user’s authority to
operate this equipment. This transmitter must not be co-located or operating in conjunction with any other antenna or trans-
mitter. For operation within 5.15 ~ 5.25GHz / 5.47 ~ 5.725GHz frequency range, it is restricted to indoor environment. The band
from 5600-5650MHz will be disabled by the software during the manufacturing and cannot be changed by the end user. This
device meets all the other requirements specied in Part 15E, Section 15.407 of the FCC Rules.
RADIATION EXPOSURE STATEMENT (TRANSMITTER):
The product comply with the FCC portable RF exposure limit set forth for an uncontrolled environment and are safe for intend-
ed operation as described in this manual. The further RF exposure reduction can be achieved if the product can be kept as far
as possible from the user body or set the device to lower output power if such function is available. The USB dongle transmitter
is approved for use in typical laptop computers. To comply with FCC RF exposure requirements, it should not be used in other
devices or certain laptop and tablet computer congurations where the USB connectors on the host computer are unable
to provide or ensure the necessary operating congurations intended for the device and its users or bystanders to satisfy RF
exposure compliance requirements. Receiver should be installed and operated with minimum distance 20cm between the
radiator & your body.
RADIATION EXPOSURE STATEMENT (RECEIVER):
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should
be installed and operated with minimum distance 20cm between the radiator & your body. Note: The country code selection
is for non-US model only and is not available to all US model. Per FCC regulation, all WiFi product marketed in US must xed to
US operation channels only.
IC STATEMENT
This device complies with ISED’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
CAUTION :
(i) the device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for harmful interference to
co-channel mobile satellite systems; (ii) the maximum antenna gain permitted for devices in the bands 5250-5350 MHz and
5470-5725 MHz shall be such that the equipment still complies with the e.i.r.p. limit; (iii) the maximum antenna gain permitted
for devices in the band 5725-5850 MHz shall be such that the equipment still complies with the e.i.r.p. limits specied for
point-to-point and non-point-to-point operation as appropriate; and (iv) Users should also be advised that high-power radars
are allocated as primary users (i.e. priority users) of the bands 5250-5350 MHz and 5650-5850 MHz and that these radars could
cause interference and/or damage to LE-LAN devices.
RADIATION EXPOSURE STATEMENT:
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. This equipment should
be installed and operated with minimum distance 20cm between the radiator & your body.
AVERTISSEMENT :
Le guide d’utilisation des dispositifs pour réseaux locaux doit inclure des instructions précises sur les restrictions susmentionnées, notamment: (i)
les dispositifs fonctionnant dans la bande 5150-5250 MHz sont réservés uniquement pour une utilisation a l’intérier an de réduire les risques de
brouillage préjudiciable aux systèmes de satellites mobiles utilisant les mêmes canaux; (ii) le gain maximal d’antenne permis pour les dispositifs
utilisant les bandes de 5250 à 5350 MHz et de 5470 à 5725 MHz doit être conforme à la limite de la p.i.r.e; (iii) le gain maximal d’antenne permis
(pour les dispositifs utilisant labande de 5725 à 5850 MHz) doit être conforme à la limite de la p.i.r.e spéciée pour l’exploitation point à point et
l’exploration non point à point, selon le cas; (iv) De plus, les utilisateurs devraient aussi être avisés que les utilisateurs de radars de haute puissance
sont désignés utilisateurs principaux (c.-à-d.,qu’ils ont la priorité) pour les bandes 5250-5350 MHz et 5650-5850 MHz et que ces radars pourraient
causer du brouillage et/ou des dommanges aux dispositifs LAN-EL.
DÉCLARATION D’EXPOSITION AUX REDIATIONS:
Cet équipment est conforme aux limites d’exposition aux rayonnements ISED établies pour environnment non contrôlé. Cet équipment doit être
installé et utilisé avec un minimum de 20 cm de distance entre la source de rayonnement et votre corps.
