O'jump 950 User manual

18/01/2021
1
(UK) Assembly Instructions
FREESTY E TRAINING BARS
Ref. : 950
N°297

18/01/2021
2
Thank you for buying this product O'jump. We advise you to read the assembly instructions
carefully. The apparatus is presented in pre-assembled parts for a simplified assembly. We
have designed this O'jump product to bring you complete satisfaction. If you need help, the
O'jump team is at your disposal to accompany you.
Warning:
This equipment must only be used by one person at a time and under the supervision of a
qualified individual, with appropriate landing mats.
Using this equipment for purposes other than those originally intended is prohibited.
Risk of injury from sudden fall of apparatus.
To avoid the apparatus tumble, the apparatus must fixed to the ground permanently.
The fixations are not included because their choice depending the ground material. Use the
appropriate fixation according the support. To get advices or fixations sets contact the
O’JUMP department.
Recommendations:
- keep these instructions for subsequent reference (inspection, maintenance, etc.).
- periodically carry out predictive maintenance.
- depending on how much it is used, have the equipment serviced yearly or every few years.
Footprint and eight:
- Apparatus 3.50 x 3.50 m 123 Kg

18/01/2021
3
Tools needed to assemble the apparatus .
Hardware listing (pre-assembled)
indexing knob
X8
X8
Index
ing
pin
X
24
M10 x 60
A
Ø22x10.5
B
X
48
X
24
M10
C
Hex wrench N°18/19

18/01/2021
4
ist of parts (pre-assembled)
Central post (1 package)
X1
ateral post (4 packages)
X4
X
2
X
2
Ø28 steel hand
-
rail
(2 packages)
Ø40 wooden hand
-
rail
(2 packages)

18/01/2021
5
Assembling the hand-rail
A
B
A
B
To insert the
indexing
pin, press
the blue button to release the ball.

18/01/2021
6
Hand-rail height adjustment
Unscrew the
indexing
knobs. Pull on the
indexing knobs to release the slide.
Slide it down or up. Release the knob in front
of the desired position. ock the two knobs by
tightening. (See picture page 7)
Repeat the operation for all four posts.
Warning :
Safety is always the main consideration when setting up an apparatus.
• It is important to always have a good understanding of the task.
• Use common sense.
. Always hold the slide with one hand when unscrewing the knobs
. Risk of injury from sudden fall of the slide.

18/01/2021
7

18/01/2021
8
Fixing the freestyle training bar to the ground
Material required :
Check with the O’JUMP service specifying the nature of your soil. The type of
anchors
and screws
depending on whether your floor is concrete, wooden floor, flexible ground...
1.
Put the hand
-
rail in the low
position and adjust the
verticality
of the uprights with the
bubble level.
A bubble
level
A drill
A
nchors adapted to
your support
Screws adapted to
your support
Wrench adapted to
your type of screws
Pencil

18/01/2021
9
Cutaway top view
2
.
With
a pencil, trace
the location of the 6 holes.
Place the lateral post and check the
correct alignment of the hand-rail using
the above dimensions.

18/01/2021
10
3.
Drill all the holes using a drill bit
appropriate
for your floor. Place the
fixation
s in the holes.
They should not be higher than the ground.
4
.
P
ut in place
the uprights
in front of
the holes, then
fix
the uprights with
appropriate
screws.