Obreey Pro 602 User manual

Quick Firmware Installation Guide
Model РВ602
WARNING! Firmware Update - important operation, during which control program
of e-book will be changed. In case of improper execution, control program may be
damaged, causing loss of device efficiency and referring to the service center. Try
to perform the upgrade procedure strictly following the instructions.
To update the device software you can download new firmware from our
website: www.pocketbook-int.com
Select your location, the model of your device in the Products section; click
the right software and documentation link to enter the section of the software
update.
Download to PC the latest firmware from the firmware section.
Then you can install the firmware on the device, follow these steps:
1. Unpack the archive content at external micro SD card or root folder of the
internal memory.
2. Turn off PocketBook Pro pressing the "On / Off".
3. Turn on PocketBook Pro by pressing the "On / Off";
4. While the device is turning on, press and hold buttons: paging "Back" and
paging "Next" until the message «Firmware update...»is appeared;
5. Attention! Follow the instructions on the screen.
Note: The device can be reloaded during update process;
6. When the inscription «Update is OK. Now please reset device »appears
on the screen, switch on the device, the firmware installation is completed.
Note: The firmware version can be checked in "Settings» ⇨ «Device
Information»
Note: If the firmware file is located in the root folder of your device, it has a higher
priority for the upgrade procedure than the file which is located at the SD card.
Troubleshooting
Error message
Reason
Repair
No update image found
File SWUPDATE.BIN is not
found at the SD card.
Try to format the SD card (previously saving all the
information on your hard drive) and copy firmware
update file to the formatted card. In case the error is
repeated, try to upgrade using another SD card.
Update image is corrupted
SWUPDATE.BIN file is
corrupted or there is no
Delete unnecessary files from the card and copy the
file SWUPDATE.BIN again. Try to download the

or Image is empty
space at the SD card.
firmware from the site www.pocketbook-int.com. In
case the error is repeated, try to upgrade using
another SD card.
File reading error
SD card reading error
Try to upgrade firmware using another SD card.
Error: The device is
installed another version
of the firmware.
The internal memory
contains the old version of
firmware file.
Remove the old firmware file from the root of internal
memory.
After checking, it was
found that the firmware
version of the device has
not been updated.
One of the requirements of
the firmware installing
program was not
implemented. See p 5. The
firmware installing was
interrupted by timeout.
Start installing the firmware again, and carefully and
on time, follow the instructions of the program. For
example: "Plug in" and "Press the center button"