OCZ Z-DRIVE User manual

1. Locate the 4-pin molex power connector
from your power supply.
2. Plug the power connector into your
Z-Drive
3. Locate an x8 or x16 PCI-Express slot and
carefully seat the drive. Be sure you have
consulted the motherboard compatibility
guidelines before installing the Z-Drive.
The motherboard compatibility guideline
is available online at
www.ocztechnology.com.
4. To set the Z-Drive as your primary boot device, you must first
define in the BIOS. It will appear as a SCSI “LUN0 LSI LOGIC”
drive.
If you are using your Z-Drive in a pre-Vista Service Pack 2, you may need to install the appropriate
drivers. Drivers are available online at www.ocztechnology.com
Z-DRIVE QUICKSTART GUIDE