Odin M12 SIDEWINDER User manual

M12 SIDEWINDER
OPERATING INSTRUCTIONS
Slide the BB reservoir door open Loud BBs into the BB reservoir. Once
the BB reservoir is full, slide the door
closed.
Pivot the crank arm into the
“open” position.
Insert your magazine into the
bottom of the M12 sidewinder. The
magazine should audibly “click”
into place.
Hold the M12 Sidewinder in a vertical
position with the loader on top, and
rotate the crank arm in a clockwise
manner. Once the magazine is full,
the clutch will engage.
Depress the magazine release
latch, and remove the magazine.
Repeat steps 1-6 to load
additional magazines

M12 SIDEWINDER
OPERATING INSTRUCTIONS (OPTIONAL)
Some magazines have stiffer springs than industry standard, and might require the adjustment of the
clutch nut. If your magazines are not getting fully loaded, locate the clutch nut on your M12 Sidewinder,
and using a 10mm wrench, rotate it clockwise 1/8 turn, and attempt to load the magazine again. Repeat
this step until the M12 loads your magazine completely.

M12 SIDEWINDER
TROUBLESHOOTING
NOTE
In most cases, malfunctions can be prevented by simply following the 6
steps outlined in the operating instructions. In the rare case that you encounter
issues with your M12 Sidewinder, review the guide below.
Problem
Causes
Solution
My magazine
won’t seat into
the M12
Sidewinder
-Out of spec magazines
-Magazine misaligned with
M12 Sidewinder
-Use only Tokyo Marui M16/M4
spec magazines
-Align magazine properly
My M12 isn’t
loading my
magazines to
their full
capacity
-Magazine has excessively
strong spring
-Clutch adjustment is too
loose
-Review operating instructions
on Page 2 of this manual

M12 SIDEWINDER
WARRANTY, CONTACT INFORMATION AND
WARNINGS
WARNING:
The M12 Sidewinder was designed for use by people 18 years of age or older. It contains small
parts that may pose a choking hazard to small children.
Warranty:
The M12 Sidewinder is guaranteed free from manufacturer’s defects for a period of one year
from the date of purchase. If during that time you encounter defects with your M12
Sidewinder, you can contact us via the email listed below, and you will be issued an RMA
number to return the M12 for repair or replacement.
This warranty is null and void if it is found that the M12 Sidewinder has been modified, abused,
or altered in such a way that the structural or individual component integrity has been
compromised.
Contact Information:
Customer support: [email protected]
Toll free: 1(800)385-8581
Fax: [phone]
ZShot Inc
746 Carle Ave
Lewis Center, OH 43035