OE Elsafe ARC-H LD User manual

Metal Frame
1.38"
(35mm)
1.38"
(35mm)
1.38"
(35mm)
1.77"
(45mm)
Cable Entry
Centre loose magnet on resonator mat template
and align magnets (thicknesses 20 -25mm)
Adjust to ensure correct clearance and
mark screw holes
Move aligned templates to desired location.
Trace around surface template
1
3
2
Fit ARC H LD with tape (provided) or
screws. Ensure cable entry is the same
end as the template cable entry
Cable
Entry
4 5
ARC H LD is designed for surfaces 20-50mm thick.
For surfaces 20-25mm use the in box magnetic alignment card and template.
For surfaces 25-50mm an electronic alignment guide is separately available, please inquire.
Ph: 1300 ELSAFE | www.oeelsafe.com.au | [e-mail]
ARC H LD INSTALLATION
Use resonator pad template for accuracy
Place Resonator Pad where resonator pad
template markings indicate
Note the cable entry on the
template and ensure the cable
end on the charging module is
at the same end.

ARC H LD INSTALLATION
Common installation errors
Pad tted over the center of the charger -
WILL NOT WORK
The charging coil is Off-Center, the
alignment guide must be used to
guarantee accuracy
Pad misaligned - WILL NOT WORK
The alignment guide must be used to
guarantee accuracy
LED Functions
Slow on/o󰀨 blue - Device is on and in
stand-by mode
Solid blue - Device in on and in charging
mode
Red - Error mode
• Foreign Object Detected - Remove metal from near
charger
• Phone is too close - Move phone greater than 15mm
away
• Plug pack issue - Use only original plug pack
• NON-compatible device - Upgrade phone
ARC-H
Pad
Coil Center
ARC-H
Connect power and check for blue LED Place phone on the Resonator Pad to charge
6 7
The ARC logo identies the coil center which
must be aligned with the Resonator Pad
8Common queries / installation problems 9
Common queries
The phone will not charge when I place the phone directly on
the charger, to check it works before installation?
The charger will not charge a phone unless it is separated (and
aligned) from the phone by at least 0.8”(20mm)
The magnets will not attract each other through my desk?
The magnets only work up to 1”(25mm). Either route the desk
underside to <1” (25mm) thick or call to
purchase the Electronic Alignment Guide
The ARC logo identifies the coil center which must be
aligned with the resonator pad
Ph: 1300 ELSAFE | www.oeelsafe.com.au | [e-mail]