Offices To Go OTGHABASE2 User manual

HEIGHT ADJUSTABLE TABLES
ASSEMBLY INSTRUCTIONS
OTGHABASE2
www.officestogo.com revised 010720
1/6 OTGHABASE2

EXPLODED VIEW
HARDWARE LIST
A x 8+2
(M8x20)
G x 2
B x 10+2
(M6x8)
H x 1 (4mm)
C x 2+2
(M6x12)
I x 1 (5mm)
D x 8+2
(M6x10)
J x 1
E x 8+2
(ST4.8x20)
K x 2+2
F x 6+2
(ST3x19)
(packed with handset and
power supply)
HEIGHT ADJUSTABLE TABLES
ASSEMBLY INSTRUCTIONS
www.officestogo.com revised 010720
2/6

STEP 1 - Assemble Cross Rail
• Do not tighten these screws
until after Step 4.
• Leave screws loose enough
to easily slide brackets along
slot.
STEP 2 - Affix Motor
• Affix motor unit to right leg
(item 8).
HEIGHT ADJUSTABLE TABLES
ASSEMBLY INSTRUCTIONS
www.officestogo.com revised 010720
3/6

STEP 3 - Assemble legs and
crossrail
• Connect cross rails to legs,
leave screws from Step 1
loose.
STEP 4 - Connect Hex Rods
• Insert hex rod into motor
(Item 12) and slide tube over
the hex rod in left leg (Item 2).
• Slide mechanism to desired
size.
• NOTE: Table top should
overhang base on the left
and right side by a minimum
of 1” and a maximum of
2.25”.
• Tighten knobs on the tube
(Item 4).
HEIGHT ADJUSTABLE TABLES
ASSEMBLY INSTRUCTIONS
www.officestogo.com revised 010720
4/6
Open
Ouvrir
Close
Fermer

HEIGHT ADJUSTABLE TABLES
ASSEMBLY INSTRUCTIONS
www.officestogo.com revised 010720
5/6
STEP 5 - Assemble end
brackets and insert spacers
• Plastic spacers (Item K)
should be placed evenly on
the center portion of the
crossrail.
• Tighten all screws securely.
STEP 6 - Assemble Table Top
• Center frame (on all sides)
on the bottom of the table
top. Use screws (Item E) to
assemble base frame to the
bottom of the table top.
• Tighten screws securely.
• NOTE: Table top should
overhang base on the left and
right side by a minimum of 1”
and a maximum of 2.25”.

ĉ
Ċ
ċ
Č
ĉ
Ċ
HEIGHT ADJUSTABLE TABLES
ASSEMBLY INSTRUCTIONS
www.officestogo.com revised 010720
6/6
STEP 7 - Assemble Power
Supply and Handset
• Tighten screws securely.