Officient STELLAR MID-BACK CHAIR User manual

PARTS INSTRUCTIONS
PART DESCRIPTION QTY
1Casters 5
25-Star Base 1
3Telescoping Cover 1
4Cylinder 1
5Seat Plate 1
61
72
8
92
INSTRUCTIONS
A. Remove all parts from the carton and separate them into part number groups as indicated in the parts list.
B. To begin assembly, place the 5-star base (2) upside down and insert casters (1) into the bottom of base (2).
C.
D. Place the telescoping cover (3) over the the cylinder (4) and rest it on the base (2).
E. Attach seat plate (5) to the bottom of seat and back cushion w/ arms (6) (with the front of seat plate facing
front of seat cushion) by using 1¼" EZ Knobs (7) for the front holes and ” EZ Knobs (8) for the rear
holes of seat plate(5)and tighten knobs. .
F. Place the pre-assembled seat and back cushions w/ arms(6) and seat plate (5) on top of gas lift (4) and
press down until fully engaged.
G. Standing in front of the chair, lift the back cushion into an upright position. Check to make sure the pins
have locked into the arm holes correctly.
H. Periodically (every 90 days) make sure that the screws are still fully tightened.
CUSTOMER SERVICE HOTLINE
800-626-6060
ATTENTION:
Make certain to fully tighten all screws
before using chair.
ASS E M B LY I NSTRUCTI O N S
STELLAR MID-BACK CHAI R
Seat and Back
Cushions w/ Arms
1¼" EZ Knobs
" EZ Knobs 2
Hexagonal Wrenches
WWW.OFFICIENTFURNITURE.COM

OPERATING FEATURES 1. TO ADJUST SEAT HEIGHT:
While seated, lean forward and reach under the right side
of the chair to locate the handle. Lift the handle and raise
your body up slightly to allow the chair to rise to the desired
height. To lower the seat, lift the handle while applying more
weight downward on the seat. The chair will descend until the
handle is released or the chair reaches the lowest position.
2. TO OPERATE TILT LOCKOUT:
3. TO ADJUST TENSION ON THE TILT:
Reach under the front center of the chair, grasp the round
knob and turn counterclockwise to make the tilt mechanism
knob clockwise until the desired resistance is found.
1
WARNINGS
1. This product should be used by only one person at a time.
2. Do not use this chair unless all bolts, screws and knobs are
securely tightened.
3. Save the hexagonal wrench. Check that all bolts, screws and
knobs are tight every three months or as needed.
4. Dispose of packing material properly. Do not use the plastic
cover as a head covering. It may cause suffocation.
5. Do not use the chair as a stepladder.
6. Use this chair for its intended purpose only.
7. The casters sold with this chair are intended for use on
carpet. They are not recommended for use on tile or hard-
ASS E M B LY I NSTRUCTI O N S
the height adjustment handle. Pull the handle all the way out
(away from the cylinder) to allow the chair to tilt backwards.
To lock the chair in the upright or vertical position, sit upright
and push the handle in towards the cylinder.
4. TO DISASSEMBLE THE BACK CUSHION:
Standing behind the chair, press the button on both sides of the
chair armrests to release the pins. Both pins must be disengaged
at the same time. Push the back cushion forward and fold the
back cushion on seat cushion.
STELLAR MID-BACK CHAI R
WWW.OFFICIENTFURNITURE.COM