oh!bike Carmela24 User manual

check & use
03
owner’s manual Carmela24

Model: Carmela24
According to EN ISO 4210-2/2015 and
EN 15194/2018.
oh!bike factoria S.L.
B66493271
Diputació 286, Baixos
08009 Barcelona
[email protected]

4
owner’s manual | check & use
check
Before riding your bike, you must make sure the
bicycle is correctly prepared for its use.
revisión
The following are 9 items that you should
check before each use.

Check that the handlebar and pedals are
not folded and that the front wheel is
perfectly perpendicular to the handlebar.

1. Press the red button.
2. Keeping the red button pressed, rotate the
lever.

5
owner’s manual | check & use
3. Release the button and turn the handlebar
perpendicular to the front wheel.
4. Turn the lever 180º again until you hear the
“click” of the red button that indicates that
the handlebar position is xed.

1. Press the pedal inwards.
2. Keeping the pedal pressed in, rotate the
pedal up or down.

6
owner’s manual | check & use
3. To unfold it, you just have to turn the pedal
upwards.

Check that the battery is correctly xed and
connected, and that it has a sufcient charge
level.

Never remove the battery without the bi-
king being switched off.
1. . Use the key to open the lock. The teeth of
the key facing the front of the bike.

7
owner’s manual | check & use
2. With the key still inserted in the lock, move
the battery by turning it outwards between
the top tubes.
3. With the help of your other hand, remove
the battery through the middle of the two top
tubes.

Check that you have the key in the lock.
that the latch is open and the battery
switched off
1. Fit the battery between the two top tubes
by rotating on the front rubber buffer and let
it fall, tting the back.

8
owner’s manual | check & use
2. Listen carefully to the click of the lock that
lets you know that the battery has been co-
rrectly secured to the frame.
3. Remove the key and store it in a safe place.

1. Check that the motor connector is con-
nected and correctly xed to the fork.
2. Press the boost button to check that there
is assistance.
Make sure that you have no one in front
of you, the bike will advance.

9
owner’s manual | check & use

Check that the height and the angle of the
saddle is correct for you and that the xing
screw is tight.
1. Set it in a position where you feel comfor-
table and tighten the screw.
2. To adjust the displacement and the ad-
justment of the angle of the saddle you must
open the screws of the saddle post head.
Do not turn the screw anymore than two
or three turns as this can cause the me-
chanism to come apart. Move the saddle
to your liking and do not exceed the mar-
ks.

10
owner’s manual | check & use

Check that the gear selector works correctly.
Gear 1 facilitates starts and slopes. Gears 2
and 3 are for high speeds.
Check that the belt tensions is correct, appl-
ying force on it. It should not have a clearan-
ce of more than 15mm.

1. Check that the wheels are properly aligned
with the fork and frame, and that they rotate
without brushing on any xed part.
2. Check the tire pressure (which should be
between 2.75 and 4.5 bar).

11
owner’s manual | check & use

Check that the brakes work correctly. Note
that the right brake lever controls the rear
brake and the left brake lever controls the
front brake.
Check that the brake levers are in a comfor-
table position for you. If not, adjust them by
loosening the screws.

Check that the bell, lights and other acces-
sories are in place and working properly.
Check that before you get on the bike you
have removed the key from the battery
and stored it in a safe place.

12
owner’s manual | check & use
If you lose the two copies of keys that
we give you, take a deep breath and keep
calm. Get in touch immediately with
Customer Service.

Remember that riding a bicycle means you
are driving a vehicle. You must know and fo-
llow the rules of circulation.

13
owner’s manual | check & use
use
Before riding your bike, you must make sure
you know all its functions and how to use them.

Here are the most important points for you to
understand its use.

Never start the electrical system with the bi-
cycle in motion. You should always turn on
the battery before you start.
To turn on the battery and POWER mode,
press the button for 3 seconds. This mode
offers maximum assistance when pedaling.
The button will light indicating the level of ba-
ttery charge, one red LED and 7 green LEDs
turn off as battery levels decrease.

14
owner’s manual | check & use
In ECO mode your pedaling assistance is re-
duced by 30%, but you increase the battery
life and you can take longer trips.
To activate or deactivate this mode, you
must press the button. The led will change
from green to orange or vice versa.
To turn off the battery, press the POWER but-
ton for 3 ‘’. The light will turn orange or green
and then turn off.
If you forget to turn off the battery, it will au-
tomatically turn off after 10 minutes.

15
owner’s manual | check & use

With the bike stopped, pressing the boost bu-
tton activates the bike’s engine up to a maxi-
mum speed of 6 km/h.
With the bike running, pressing the boost bu-
tton will get an extra assistance of 40% (for a
limited period).

The process of charging the battery lasts be-
tween 3 and 4 hours
To charge the battery you have to remo-
ve it from the bicycle. Never remove it
without rst turning it off.

1. Connect the charger to the power. The
green light on the charger will turn on.
Recharge the battery only with the su-
pplied charger.

16
owner’s manual | check & use
2. Connect the charger to the battery tur-
ned off. A flashing green light will come on,
showing the current charge level. When the
battery is fully charged, this light will turn off.
Remember that the battery connector is
magnetic and can attract metal objects
that may remain in the connector.

The battery has two USB connectors in its
base, where you can connect any device an-
ywhere.
For reasons of road safety, they cannot
be used when the battery is installed on
the bicycle.

17
owner’s manual | check & use

EN 1811 edition - oh!bike factoria S.L
03
check & use