Omcan PA10176 User manual

SAFETY
Please take notice that the unit will still be too hot to handle immediately after
use.
The Contact Grill has a thermal cut-off safety device to avoid over heating.
If the power cord is damaged, it must be replaced by qualified technician.
MAINTENANCE
Be sure to always wash the grill plates after each use to remove any residue
that may have accumulated.
For cleaning cast iron plate, please use warm soapy water while still warm. Do
not use cold water on hot plate.
After cleaning, be sure the oil tray must be dry thoroughly before putting them
back to the unit.
Do not immerse completely in water or any liquid to clean.
The appliance is not to be cleaned with a water jet.
HELP
If the Omcan Contact Grill does not work, please check the following:
1.The power supply is correct and switched on.
2.The positions of switch and thermostat are correct.
ELECTRIC COUNTER TOP
CONTACT GRILL
USER’S GUIDE

BASIC SPECIFICATION
Model Voltage Power Dimension
PA10176 240V/60HZ 3200W 475(W) X 390(D) X 260(H)
PA10177
PA10178
EXPLOSION GRAPH
Body
Swi t c h
Ha n d l e
Pl ug and l ead
Li d
Cast lron(bottom)
El ement(bottom)
Oil tray
Di a l Foot
INSTALLATION
Take out the Omcan Contact Grill from the packaging and locate the unit on a
firm level surface.
When this appliance is to be positioned in close proximity to a wall, partitions,
kitchen furniture, decorative finished, etc., it is recommended that they be made
of non-combustible material, if not, they shall be clad with a suitable
non-combustible heat-insulating material, and that the closet attention be paid to
fire prevention regulations.
Once the Contact Grill has been placed in position by consulting International
Standards and regulations. Cleaning the cast iron plate thoroughly is advised.
Warm up the cast iron plate for 10 minutes until all smoke and/or odor has
dissipated. Switch off and unplug the unit, then use warm, soapy water to clean.
NEVER USE COLD WATER ON THE HOT PLATE.
ELECTRICALDIAGRAM
El ement El e ment
El ement
Indicator light
Ther most at
swi t ch
Ther mo cut out
swi t ch
El ement
Ther most at
N
LE
Ther mo cut out
I ndi cat or l i ght
240V
OPERATION
Always preheat the grill before use until the ready light illuminates.
Lift the top grill plate, arrange food on the bottom plate and bring top plate back
down to make contact with food and begin cooking. If additional sandwiches are
desired, lower the lid to preserve the heat while you prepare the additional
sandwiches. When not cooking, the thermostat is turned off, unplug the unit.