Omegawave COACH User manual

Quick Start Guide for Tesng on COACH
 Open Omegawave App.
 Have the athlete to be measured to put on all equipment: (See back for picture)
 Thoroughly wet both ECG pads on the chest strap, then put on
 Aach 2 electrodes—one in the center of the forehead, the other on the base of
the dominant thumb
 Connect the CNS cables to the electrodes, and then aach the cables to the sen-
sor
 Connect the sensor to the chest strap and check that the Omegawave logo is not
upside-down relave to the athlete’s head & shoulders
 Have the athlete lie down and remain sll during tesng.
 Make sure the iPad’s Bluetooth is on, the volume is turned up, the device is connect-
ed to a WiFi network or cellular data, and that the Omegawave sensor is paired to
the app (If you cannot nd the sensor in the Omegawave App, check to make sure it
is not paired in the iPad’s Bluetooth sengs—it will be listed as “OW-CB2”).

Quick Start Guide for Tesng on COACH
 Select the athlete to be tested.
 Press ‘Measure’ at the top of the screen.
 The green “Start measuring” buon will light up and
become acve once the app detects a pulse and CNS
data. Press the buon to start the test and you will
hear a “Beep”. A 2nd “Beep” will indicate the test is
nished, aer which you access a screen where you
can enter relevant notes and select whether the
test was “Before” training or “Aer” training.
 Once you have entered any addional informaon and selected “Before” or
“Aer”, press “Save & Analyze” to see the results of the test.