Adjustment Guiding
Choose Parameters
Now, we have two modes, refreshment priority and brightness priority. Refreshment
priority is for high refresh rate, and you will get good feedback by mobile phone or camera,
but the brightness is lower. If you use brightness priority, you will get higher brightness but
photo by mobile phone or camera may not so good. Usually,for indoor screen, brightness is
not so important,so you can choose refreshment priority;But for outdoor screen,brightness
is needed,in this situation,need to choose brightness priority.
For brightness mode, there are 3 modes: lower, normal or high brightness. If the display
mode is fixed, then, the higher the brightness is, the lower the refreshment will be. Or, on
the same refreshment, the control width will be smaller. So, when the brightness is enough,
you can choose lower brightness mode, as to obtain a better refresh rate and shooting
effect.
On the same refresh rate, if the control size is the same, then, the gray grade is higher,
the effect will be better. But if the gray grade is higher, the control size will be smaller. So, we
usually suggest to use 4096 gray scale, do not over than 16384.
It is not correct that the refresh magnification is higher, the effect will be better. If the
refresh rate is enough, the refresh magnification is lower, the shoot effect will be better.
Replacement clock is also an important parameters. The higher the replacement clock is,
the control size will be larger(on the same refresh rate). But some kinds of modules are not
so good with quality, cannot use higher replacement clock, usually, there will be some
special flashing on the screen.
Gray from the first grade
If users need better low gray effect, you can choose. But the effect will be not so good, it
will be weird by your eyes. So, usually, we do not suggest.
