What’s in the Box?
Plug in the wireless charging stand
Place your smartphone onto the stand
The Fine Print
12
1. Wireless Charging Stand
2. Charging Cable
Check to make sure you have
01
02
Using the charging cable that came in the box, insert
the micro USB plug into the micro USB port on the back
of the wireless charging stand. Insert the USB plug into
any USB power source, (for example: a wall charger, car
charger or computer USB port.)
Place your Qi-enabled smartphone
onto the center of the stand. The
charging icon will appear on your
smartphone screen to indicate your
phone is charging.
This equipment has been tested and found to comply with the limits
for a WPC device, pursuant to Part 18 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in
a residential installation.
NOTE: This equipment has been tested and found to comply with the
limits for a wireless power charger, pursuant to Part 18 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment o and on,
the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit dierent from
that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Changes or modiications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
product.
This equipment complies with FCC radiation exposure limits set forth for
an uncontrolled environment. This equipment should be installed and
operated with minimum distance 20cm between the radiator and your
body. This transmitter must not be co-located or operating in conjunction
with any other antenna or transmitter.
