I. Features:
• Outer Sensor High/Low Temperature Alarm Setting
• Large Display for Room / Outer Sensor Temperature
• Maximum / Minimum Temperature Memory
• Room / Outer Sensor Temperature Switchable
• °C/°F Exchange
• Foldaway Stand
• Magnetuc attachment
II. Specifications:
Measurement Range: -10 to +50°C /14 to +122°F (Room Temperature)
-50 to +70°C 1-58 to +158°F (Fridge Temperature)
Accuracy: ±1°C ± 1.8°F
Display Resolution : 0.1°
Battery: 1.5 volt size AAA /UM4 or equivalentxl piece (included)
Sampling Rate: 10 seconds
Sensor cord Length: 3 meters
1. Installation:
Power On: Pull down the battery cover and pull out the insulation strip in
the battery comparyment. Base Unit Setting :Wipe the desired installation area
clean, then remove the protective paper from Velcro magic tape on unit and
press the unit firmly on the installation area.
Outer Sensor Setting :
a) Out Door Setting: Use the double side tape to stick the rectangular shape
sensor holde on the desired installation area;
b) Aquarium Setting: Press the sensor suction cup firmly onto the glass
inside the aquariu tank with a distance of about 100mm/4” under the water
level.
2. °C/°F Select T
Press [°C/°F] butt on on the unit back side to select the temperature unit
3. Room / Outer Sensor Temperature Select:
Press [ IN / OUT ] butt on on select room or outer sensor
temperature .The IN symbol indicates that the reading is for room
temperature andthe OUT symbol indicates that the reading is for outer
sensor temperature.
4. Maximum& Minimum Temperature Memory Display:
• Press [MAX/MIN] to display maximum temperature memory {MAX
symbol will be displayed}
• Press [MAX/MIN] again to display minimum temperature memory
{MIN symbol will be displayed}
• Press [MAX/MIN] again to take instant temperature reading.
• Holding [MAX/MIN] one second to reset minimum and maximum
temperature memory
5. High/Low Temperature Alarm Setting (for outer sensor only)
• Press & hold [ALARM SET] button then the HIGH/OUT icon will be
flashing
• USE[°C/°F] button to set the desired alarm high limit
• Press [ALARM SET] button once more and the LOW/OUT icon will be
flashing
• USE[°C/°F] button to set the desired alarm low limit
• Press [SET] again to finish the setting
• During the limit setting .holding the [°C/°F] butt on will advance the
value automatically
• If the temperature value is out of the set limit then the alarm will sound
• Press any button will stop then alarm sound.
