performance and construction.
We guarantee some parts in these
instruments for up to 10 years under
the following conditions:
(i) In the case of defects attributable
to faulty processing or materials,
we will assume responsibility
for the labour and material costs
during the first 5 years after
purchase. We reserve the right to
decide whether defective parts
should be repaired or replaced.
(ii) During the next 5 years we
will assume responsibility for
material costs only, charging
corresponding labour costs.
(iii) We will accept no liability for
damage caused by incorrect
use, water penetration or for any
repairs or actions which have
been carried out outside our firm.
(iv) Parts such as rubber eyecups
and rubberised coatings etc. are
excluded from the guarantee.
This guarantee is in addition and
does not affect your statutory rights.
Care and cleaning
Opticron HDF eyepieces require
little maintenance but occasionally
the outside surface of the eyelens
will need cleaning. To avoid
damaging this surface please read
the following carefully.
(i) Gently remove excess dirt and
dust using a compressed air
device or blower brush. Caution:
Hard and persistent rubbing of
dirty surfaces can cause abrasive
scratches on the surface of the
glass which may distort viewing.
(ii) Breathe on exposed glass surface
and then wipe with an optical
cleaning cloth (code 30277) in a
circular motion until the surface
is clean again.
Do not attempt to dismantle the
eyepiece as this will invalidate the
guarantee.
Guarantee
Opticron HDF Eyepieces are of
a very high quality both in their
