OPW PetroVend PV200 User manual

AVI - PV200 Option Installation
F M S Pa r t N u mb e r 2 0 -4 4 6 5
WARNING: To prevent an electrical shock hazard, de-energize the
Terminal before you do this procedure! Push the Terminal rocker switch on
the Power Supply to the O(Off) position.
Install the VIS Controller Assembly
OPW Fuel Management Systems, 6900 Santa Fe Drive, Hodgkins, IL 60525 • 708-485-4200 • www.opwglobal.com/opw-fms
Doc. No.: M00-20-4465 Rev.: 1
Page 1 of 2

1. Remove the nuts from the studs on the back wall of the PV200 enclosure where the VIS Controller
Assembly is to be installed.
2. Attach the four (4) standoffs (50-0443) to the studs.
3. Hold the VIS Board Assembly (20-0415-XX) on the standoffs as shown above.
4. Put the four (4) screws through the holes in the VIS assembly and attach them to the standoffs.
5. Connect the 20-1732 AVI Petro-Net Cable to one of the three Molex connectors (J6/J7/J8) of the Petro-
Net Power Hub Board (20-0414).
6. Connect the Yellow, Violet, Black and Red terminal wires of the 20-1732 cable to the J1 Terminal Block
of the VIS Board Assembly as shown in the illustration above.
Install the Antenna
For information on the installation of the recommended antenna types (Body Mount or Panel style) refer to
M1040-ANT AVI Antenna Installation.
OPW Fuel Management Systems, 6900 Santa Fe Drive, Hodgkins, IL 60525 • 708-485-4200 • www.opwglobal.com/opw-fms
Doc. No.: M00-20-4465 Rev.: 1
Page 2 of 2