ORCATORCH D500 User manual

ORCATORCH D500
ORCATORCH D500 is a portable magnetic controlled flashlight for professional diving. It is
equipped with a totally sealed magnetic controlled side switch that provides flexible operation
underwater. Using the latest USA CREE XM-L2(U2) LED, max 700 lumens output and over 18
hours runtime, this portable diving light offers three brightness levels and one strobe mode for
different diving environment use. Plus simple style appearance, robust water pressure resistant
construction, we believe it will be your best lighting tool for diving.
Product features
üCree XM-L2(U2) LED, max 700 lumens output
üUses 1*18650 Li-ion battery
üMagnetic controlled side switch, high waterproofness for easy operation underwater
üWater pressure resistant construction, depth rated to 150 meters
üStandard included wrist strap fastens the flashlight to the back of your hand
üHigh efficiency constant current circuit, constant brightness
üReverse polarity protection, to protect from improper battery installation
üAircraft-grade high strength aluminum MATERIAL
üPremium Type III military hard-anodized seawater-corrosion-resistance finish
üAlloy aluminum reflector with professional optical analysis
üToughened glass with high water pressure resistance under deep water
Technical Parameters:
ANSI/NEMA FL1 High Middle Low Strobe
Output 700 lumens 270 lumens 65 lumens 700 lumens
Runtime 1h30min 3h40min 18h10min /
Beam Distance 230m(on land)
Intensity 13800cd
Impact Resistant 1m
Waterproof under water 150m
Working voltage 3 –4.5 V
Dimension 152mm(Length) x 28mm(Diameter) x 45mm(Head)
Net weight 216g（excluding battery）
Accessories O-ring, wrist strap, lanyard
Notice: Stated data has been measured according to the international flashlight test standards
ANSI/NEMA FL1 using one ORCATORCH 18650 Li-ion battery(3.7V, 2600mAh) under laboratory
condition. The parameters are approximate and may vary between flashlights, batteries, and
environments.

Operation Instruction:
1. ON/OFF: Insert the battery and tighten the light head to turn on the flashlight at default low
mode, then you can press the side switch to turn it off.
2. Mode Selection: Press the side switch to switch mode among high, middle, low and off. Keep
pressing the side switch for 2 to 3 seconds to get the hidden strobe mode, and press again to
get back to the previous mode.
Battery Replacement:
1. As shown in the figure, insert the battery with the anode side (+) toward the light head.
2. Please do not reverse battery to avoid damage to the flashlight and battery.
3. Please do not use battery with higher voltage than flashlight working voltage.
4. Please do not use battery with damaged surface or deformation to avoid short circuit,
explosion, leakage, etc.
Usage and Maintenance
²Please keep the flashlight away from high intensity magnetic fields, or the switch may fail to
function.
²Please clean the surface of the flashlight with fresh water after use in case of the seawater
corrosiveness.
²Please don't disassemble the sealed head, doing so may cause damage to the flashlight and
will void the warranty.
²We recommend the use of high quality batteries. If the flashlight will not be used for a long
time, remove the batteries to avoid damage from electrolyte leakage or battery explosion.
²Please replace the O-rings if they are damaged after prolonged use and regularly lubricate
the o-rings so as to not erode the rubber. Doing so will keep the flashlight properly sealed
against water.
²Please clean the contacts of your light from time to time, especially when the light flickers or
doesn’t light up. There are probably several reasons for a flickering or not working light:
Reason A: The batteries need to be replaced.
Solution: Replace batteries (Please confirm correct installation of + and - terminals).
Reason B: The threads, PCB board contact or other contacts are dirty.
Solution: Clean the contact points with an alcohol soaked cotton swab.
If the methods above don't work, please contact the distributors and refer to the warranty
policy.

Product Warranty
We will replace products afflicted with manufacturing defects within 30 days of purchase and
repair a light free of charge within 24 months of purchase if problems develop under normal use;
if repair is required after 24 months from the date of purchase, we will charge for parts. The total
repair fee is dictated by the cost of the replaced materials.
Warning
The flashlight is high intensity lighting device and capable of causing eye damage, please avoid
shining the light directly into the eyes.