http://www.orion.ua
3
11. Do not use outdoors.
12. Do not use the appliance for other than intended use.
13. The kettle can only use with the stand provided.
14. If the kettle is overfilled, boiling water may be ejected.
15. Save these instructions.
OPERATION
It is recommended that operate the kettle several times following the below instruction and
discard off the water before first use. This will remove the material or dust remained in the
appliance which is caused by the manufacturing process.
1. Open the lid by turning the Lid up while pressing the Lid lock and fill water into the kettle.
Then replace the lid otherwise the kettle could not be cut off power automatically after water
being boiled.
Caution: the filled water level must be between the Max and Min level as indicated on the
housing. Too less water will do damage to the heat element and if the water is overfilled,
boiling water may be ejected.
2. Replace the kettle on the Power Base and connect to power supply. Position the kettle so
that the spout of kettle is facing away from you.
3. Press down the switch and the lamp will be illuminated. And water begins to be heated up.
Do not remove the lid while the water is boiling.
4. Power will be cut off automatically and switch will switch off the kettle once water has been
boiled. And the lamp will be off.
5. The boiling process can be terminated at any time by lifting the kettle off the Power Base.
CAUTION:
-Never operate the appliance empty. In the event of this case occurred, the thermal cut-
off inside the kettle would operate to cut off power automatically. Unplug the appliance
and let it completely cool down.
-The filter must be in place during operation otherwise water spillage may occur.
-If the kettle is overfilled boiling water may be ejected.
CLEANING & MAINTENANCE
1. Remove the plug from wall outlet and let the appliance completely cool down before
cleaning.
2. Do not immerse power cord, kettle and Power Base in water.
3. In order to maintain the polish of the outer surface, do not use abrasive cleaner to wipe the
housing.
4. Periodical descaling is needed. The interval of descaling depends on the hardness of water
in your living area and the frequency your using the kettle.
5. The Filter can be detached for easier cleaning simply by pulling it out. To attach, insert the
Filter into the support dent.
6. The power cord can be rounded around the bottom of power base for storage.
7. Do not attempt to dismantle the kettle or power base. No user serviceable parts inside it. For
any problem, contact the authorized service facility for help.