OSP Designs POLARIS PLR828-ES User manual

PLR828-ES
POLARIS LAPTOP CART
ASSEMBLY INSTRUCTIONS
LIMITED WARRANTY
OSP Designs Warrants, to the original purchaser its products to be free from defects in material and workmanship for a period of 90 days. Defects
and damage from misuse, abuse, negligence, alteration, accident, vandalism, rusting, acts of nature or any other event beyond the control of OSP
Designs is not covered. The warranty does not cover cosmetic damage that may result from normal use. Liability for incidental or consequential
damages is excluded. The user assumes all risk of injury resulting from use of this product. This warranty gives you specific legal rights, and you
may also have other rights which vary from state to state.
To make a warranty claim, contact Customer Service, provide model number, sales receipt and description of the problem. It is the customer’s
responsibility to prepay freight on any components returned to the factory. OSP Designs will pay return freight on components covered under
terms of warranty.
Our quality standards are among the highest in the industry. Sometimes, no matter how hard we try, there are times when hardware is missing.
Our Parts Department will do everything possible to promptly remedy the problem. Contact us via email parts@officestar.net, by Fax
1-909-930-5629, or toll free parts number 1-800-950-7262, Monday through Friday 8:00 a.m. - 5:00 p.m. Pacific Time. OSP Designs P.O. Box
3520 Ontario, California 91761 USA
WARNING
1. Do not use this product unless all screws and bolts are securely
tightened.
2. Check that all screws and bolts are tight every three months or as
needed.
3. Dispose of packing material properly. Do not use plastic cover as
head covering. It may cause suffocation.
4. Do not use this product as a stepladder.
5. Use this product for its intended purpose only.
6. Intended for residential use only

Neck
Clamp

Insert both Locking Casters (E) to front of Base (5) and both Casters (F) to rear of Base (5). Push hard until you feel or hear caster snap into place.
STEP 1
Secure Post (3) to Base (5) using two Flat Washers (B), two Lock Washers (C) and two Bolts (A). FULLY TIGHTEN ALL BOLTS (A) USING
WRENCH (D).
STEP 2

Slide Neck (2) down into Post (3).
STEP 3
Secure Clamp (4) to rear Post (3) using Rubber Washer (H) and Knob (G). FULLY TIGHTEN KNOB (G).
STEP 4

Slide panels of Table Top (1) outwards. Attach Table Top (1) to Neck (2).
STEP 5
Slide panels of Table Top (1) to secure Table Top (1) to assembly.
STEP 6

To adjust table top, loosen Knob (G), raise or lower table top, tighten Knob (G) once desired height is reached.
NOTE: BE CAREFUL NOT TO LOOSEN KNOB (G) COMPLETELY.
HEIGHT ADJUSTMENT
ATTENTION: MAKE SURE BOLTS & KNOBS ARE ESECURELY TIGHTENED BEFORE USING THIS PRODUCT.