osprey video TALON 4K-SC User manual

QUICK START GUIDE
TALON Encoder
Models: 4K-SC | UHD-SC
H.265 | H.264
© 2021 Osprey Video. All rights reserved.
Osprey® is the registered trademark of Osprey Video. Microsoft®, Any other product names, trademarks, trade names, service
marks, or service names owned or registered by any other company and mentioned herein are the property of their respective
companies.
No part of this specification may be reproduced, transcribed, transmitted or stored in a retrieval system in any part or by any means
without the express written consent of Osprey Video.
Osprey Video reserves the right to change any products herein at any time and without notice. Osprey Video makes no
representations or warranties regarding the content of this document,
and assumes no responsibility for any errors contained herein.

Configure the Osprey Encoder
•Open the Osprey BOSS PRO application
•Select the correct encoder by clicking (*)
Note: If the Encoder’s IP address is known
you can enter it direct into your browser
•When the SETTINGS window opens
click “Open Web Interface”
•When the browser opens enter
Username: admin
Password: osprey

•Web GUI opens to the Encoder DASHBOARD
•Select “Output Channel 1”
•Encoder configuration settings
Configure the Osprey Encoder

Select the delivery protocol first. The video
and audio options will change depending
on what output method is selected.
Select the video encoding settings. Note
that the default settings are generic.
Your needs may be different. It is
especially important to select a bitrate
that can be supported by your network.
Configure the Osprey Encoder

The encoder supports up to eight stereo
pairs of audio. Some protocols (rtmp) only
support a single pair. Enable audio and set
the codec and bitrates from this panel.
To begin encoding, select
“Start” from the action menu.
Configure the Osprey Encoder